Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: ORCO ERECTION, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of ORCO ERECTION, INC. in 401 14TH ST., WASHINGTON, MO 63090 (NAICS 000000). OSHA activity number 116101502.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Orco Erection, INC. — free Get an email when a new federal OSHA severe-injury report for Orco Erection, INC. is published. One employer, no account, unsubscribe in one click.
Establishment
ORCO ERECTION, INC.
Site address
401 14TH ST.
City
WASHINGTON
State
MO
ZIP
63090
Mailing
816 S. KIRKWOOD, KIRKWOOD, MO 63122
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Y
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
1761
Employees
4
Ownership type
A
Industry flags
Construction safety.

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 4 exposed
Issued
Apr 19, 1993
Abate by
Apr 30, 1993
Penalty
Initial $2,000 · Current $1,500 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not furnish employment and a place of employment which
were free from recognized hazards that were causing or likely to cause
death or serious physical harm to employees in that employees were
exposed to potential injury from falls caused by lack of fall proection
for employees:
(a)  Jobsite, employees working on the roof with a 1 1/2  to 12
pitch, approximately 25 ft. above ground level; were not
wearing a harness and lanyard or utilizing any other type of
fall protection equipment.
While ultimate responsibility for correcting the hazard rests with the
employer, given his/her superior knowledge of the work place, feasible
and acceptable methods to correct this hazard, among others are:
(1)  Provide a mounting cable horizontally located across the length
of the roof which would, when used as a tie-off point for the
lanyards attached to employee's safety belts or harnesses, limit
the distance of a possbiel fall to 6 feet or less;
(2)  Provide safety belts or harness and lanyards, which are
appropriate
for the conditions of use for all affected employees;
(3)  Train employees in the proper use of these devices; and
(4)  Provide effective enforcement to ensure that employees working
at elevated heights have suitable fall protection.
Recent events (2)
  • — I (S) $1500.00
  • — Z (S) $2000.00

View Orco Erection, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 116101502.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.