Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: THE VIRGINIAN GOLF CLUB

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of THE VIRGINIAN GOLF CLUB in 15219 CLUB COURT, BRISTOL, VA 24201 (NAICS 000000). OSHA activity number 125463513.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch The Virginian Golf Club — free Get an email when a new federal OSHA severe-injury report for The Virginian Golf Club is published. One employer, no account, unsubscribe in one click.
Site address
15219 CLUB COURT
City
BRISTOL
State
VA
ZIP
24201
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
7997
Employees
55
Ownership type
A
Industry flags
Manufacturing safety.

4 citations on file for this inspection.

510001 A

Serious Gravity 03 1 instance 10 exposed
Issued
Jan 8, 1998
Abate by
Feb 1, 1998
Penalty
Initial $1,250 · Current $1,000 Reduced
40.1-51.1.(a):  The employer did not furnish employment and a place
of employment which were free from recognized hazards that were
causing or likely to cause death or serious physical harm to
employees in that employees were exposed to:
The Virginian Golf Club, Jonesboro Road, Bristol, VA -  The park
brakes on the John Deere "Turtle"; Model #1800; S/N M01800G010210,
and the Kawasaki "Mule" Model # KAF620C; S/N KIAFCC18RB500489, were
not in working condition as prescribed in ANSI B71.4-1990; Safety
Specifications for Commercial Turf Care Equipment; Section
6.4.3.1.1.
One feasible and acceptable abatement method, among others, to
correct this hazard is for the employer to purchase and install the
parts required to make the park brakes functional.
Recent events (2)
  • — Y (S) $1000.00
  • — Z (S) $1250.00

510001 A

Serious Gravity 03 1 instance 6 exposed
Issued
Jan 8, 1998
Abate by
Jan 20, 1998
Penalty
Initial $1,250 · Current $1,000 Reduced
40.1-51.1.(a):  The employer did not furnish employment and a place
of employment which were free from recognized hazards that were
causing or likely to cause death or serious physical harm to
employees in that employees were exposed to:
The Virginian Golf Club, Jonesboro Road, Bristol, VA -  The
employer allowed their employees to operate a Ransomes "Turf Trac"
Tractor; Model 420; S/N G3130, with blower attachment while the
steering wheel was broken and held together with duct tape in three
different areas.  The broken steering wheel was unstable and could
limit the operator's ability to safely drive the tractor.
One feasible and acceptable method, among others to correct this
hazard is for the employer to follow the manufacturer's
recommendations contained in the operator's manual and replace the
worn and damaged steering wheel with a new one.
Recent events (2)
  • — Y (S) $1000.00
  • — Z (S) $1250.00

510001 A

Serious Gravity 03 1 instance 3 exposed
Issued
Jan 8, 1998
Abate by
Jan 20, 1998
Penalty
Initial $1,250 · Current $500 Reduced
40.1-51.1.(a):  The employer did not furnish employment and a place
of employment which were free from recognized hazards that were
causing or likely to cause death or serious physical harm to
employees in that employees were exposed to:
The Virginian Golf Club, Jonesboro Road, Bristol, VA -  The
employer allowed their employees to operate a John Deere; Model
1145; S/N M01145X010268, mowing tractor (equipped with a rollover
protection structure) with a seat belt that was not adequate for
restraining the operator in the event that the tractor overturned
in that the defective seat belt could be pulled a part using
minimal force.
One feasible and acceptable method, among others to correct this
hazard is for the employer to remove the existing seat belt system
and replace it with a new seat belt system that will adequately
restrain the operator.
Recent events (2)
  • — Y (S) $500.00
  • — Z (S) $1250.00

510001 A

Other-than-serious Gravity 03 1 instance 10 exposed
Issued
Jan 8, 1998
Abate by
Jan 20, 1998
Penalty
Initial $1,250
40.1-51.1.(a):  The employer did not furnish employment and a place
of employment which were free from recognized hazards that were
causing or likely to cause death or serious physical harm to
employees in that employees were exposed to:
The Virginian Golf Club, Jonesboro Road, Bristol, VA -  The
employer allowed their employees to operate a John Deere Utility
Vehicle (Turf Care Equipment); Model 1800; S/N M01800G010210, while
the speed control lever was restrained in the fast position with a
piece of wire.  ANSI Standard B71.4-1990; Section 6.1.3.6 states
that speed control mechanisms must have a neutral position from
which the control is actuated.
One feasible and acceptable abatement method, among others, to
correct this hazard is for the employer to have the speed control
lever repaired.
Recent events (2)
  • — Y (O)
  • — Z (S) $1250.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 125463513.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.