HAMDEN, CT —
OSHA Inspection: TOWN OF HAMDEN DPW P&R DIV EQUIPMENT STORAGE BLDG
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of TOWN OF HAMDEN DPW P&R DIV EQUIPMENT STORAGE BLDG in 1255 SHEPARD AVENUE, HAMDEN, CT 06518 (NAICS 000000). OSHA activity number 126889674.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- TOWN OF HAMDEN DPW P&R DIV EQUIPMENT STORAGE BLDG
- Site address
- 1255 SHEPARD AVENUE
- City
- HAMDEN
- State
- CT
- ZIP
- 06518
- Mailing
- 2750 DIXWELL AVENUE, HAMDEN, CT 06518
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 7538
- Employees
- 8
- Ownership type
- B
Citations
9 citations on file for this inspection.
5(a)(1)
- Issued
- Jan 22, 1997
- Abate by
- Mar 24, 1997
- Penalty
- Initial $350 · Current $350
General-duty citation text
31-372-101 Section 31-370(a) of the Connecticut Occupational Safety and Health Act: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of improperly maintained Joyce automobile lifts: Location: (A)Maintenance Shop. (1)Mechanics were servicing automobiles on Joyce automobile lifts that had missing locking devices and were not inspected on a periodic basis. Feasible and useful abatement methods for eliminating these hazards include, but are not limited to, the following: (1)Insure all lifts are adequately maintained in accordance with lift manufactures procedures on a timely basis. (2)Insure all lifts are periodically inspected on a recurring basis by a qualified inspector who is qualified to perform these inspections through experience in installation or field service work for users, manufactures, distributors or service organizations for automotive lift products. (3)Insure that any lift needing maintenance or repairs is taken out of service and not used until deemed mechanically safe. (4)Insure that lift operators are instructed in the safe use and operation of the lift. (5)Insure that the lift operators use all applicable safety features provided on the lift, and operate the lift in accordance with lift manufacturer instructions. (6)Insure that the lift operators inspect the lifts on a daily basis for: (a)accessibility of the operating procedures, safety tips, and generic safety material; (b)accessibility and readability of safety warning labels; (c)the rated load capacity of the lift; (d)proper operation of the lift controls, restraints, and locking devices; (e)deformation or excessive wear of any of the lift structural elements; (f)deformation or excessive wear of other components such as hoses, electrical wires, drive chains, cables, or screws; (g)damage or excessive wear on any of the lift contact points which engage the vehicle during lifting, whether they engage the tires, frame, body, or axles; (h)evidence of hydraulic or pneumatic leaks; (i)unusual noises, sudden movements, erratic operation or evidence of chips or filings during use;(j)cracks or loose concrete around floor anchor bolts.
1910.22 A01
- Issued
- Jan 22, 1997
- Abate by
- Feb 24, 1997
- Penalty
- Initial $280 · Current $280
1910.22 B01
- Issued
- Jan 22, 1997
- Abate by
- Feb 24, 1997
1910.176 B
- Issued
- Jan 22, 1997
- Abate by
- Feb 24, 1997
1910.1200 E01
- Issued
- Jan 22, 1997
- Abate by
- Mar 24, 1997
- Penalty
- Initial $280 · Current $280
1910.1200 H01
- Issued
- Jan 22, 1997
- Abate by
- Mar 24, 1997
- Penalty
- Initial $280 · Current $280
1910.141 A05
- Issued
- Jan 22, 1997
- Abate by
- Feb 24, 1997
1910.254 D09 III
- Issued
- Jan 22, 1997
- Abate by
- Feb 24, 1997
1910.303 G01 II
- Issued
- Jan 22, 1997
- Abate by
- Feb 24, 1997
More inspections at Town of Hamden DPW P&R DIV Equipment Storage Bldg
View Town of Hamden DPW P&R DIV Equipment Storage Bldg's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in CT
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 126889674.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.