Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,196,991Inspections Most recent open 2026-08-24 Last loaded 2026-08-27

OSHA Inspection: P & E WOODWORKING INC.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of P & E WOODWORKING INC. in NORTH BOYER, SANDPOINT, ID 83864 (NAICS 000000). OSHA activity number 17731290.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch P & E Woodworking INC. for free Get an email when a new federal OSHA severe-injury report for P & E Woodworking INC. is published. One employer, no account, unsubscribe in one click.
Site address
NORTH BOYER
City
SANDPOINT
State
ID
ZIP
83864
Mailing
POST OFFICE BOX 908, SANDPOINT, ID 83864
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
2499
Employees
25
Ownership type
Private (A)
Industry flags
Manufacturing safety.

2 citations on file for this inspection.

5(a)(1)

Serious Gravity 06 1 instance 3 exposed
Issued
Mar 24, 1989
Abate by
Mar 28, 1989
Penalty
Initial $300 · Current $300
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The
%%
employer did not furnish employment and a place of employment which were
free from recognized hazards that were causing or likely to cause death
or serious physical harm to employees in that employees were exposed to:
a) On or about October 11, 1988 and at times prior to, employees at
P & E Woodworking, Inc. were required to operate a finger jointer
which had been malfunctioning for at least a week. The finger jointer
had not been removed from service nor had operators been warned that
it might cycle unexpectedly. Employees were exposed to possible
amputation of fingers.
Among other methods, one feasible and acceptable abatement method to
correct this hazard is to:
Install an air dryer in the pneumetic system to prevent water from
collecting in cylinders and valves, and develop procedures for all
equipment operators so that new operators, (or at shift changes) are
advised of possible malfunctions.

1910.1200 H

Other-than-serious Gravity 02 1 instance 25 exposed
Issued
Mar 24, 1989
Abate by
Apr 27, 1989

View P & E Woodworking INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 17731290.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.