RIVER FALLS, WI —
OSHA Inspection: HELPING HAND MAINTENANCE COMPANY
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of HELPING HAND MAINTENANCE COMPANY in 212 MAIN ST., RIVER FALLS, WI 54022 (NAICS 000000). OSHA activity number 300252012.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HELPING HAND MAINTENANCE COMPANY
- Site address
- 212 MAIN ST.
- City
- RIVER FALLS
- State
- WI
- ZIP
- 54022
- Mailing
- W10197 STATE RD 29, RIVER FALLS, WI 54022
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1799
- Employees
- 2
- Ownership type
- A
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- May 3, 2002
- Abate by
- May 9, 2002
- Penalty
- Initial $600 · Current $300 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of falling from a Boom-Supported Elevating Work Platform. (a) At the jobsite located in River Falls WI, an employee was in the process of dismantling and removal of a sign in the front of 212 Main Street while using a work platform without wearing personal fall arrest equipment. Employee was exposed to a fall hazard of approximately 10 feet. Among other methods, feasible and acceptable methods of abatement to correct this hazard would be to comply with American National Standards Institute (ANSI) A92.5- 1992, Standard for Boom-Supported Elevating Work Platforms, which requires that employees operating the work platform wear fall arrest equipment as required by Section 8.8(g).
Recent events (2)
- — I (S) $300.00
- — Z (S) $600.00
More inspections in this industry (NAICS 000000)
More inspections in WI
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 300252012.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.