READING, PA —
OSHA Inspection: B&W CONSTRUCTORS AND EQUIPMENT, INCORPORATED
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of B&W CONSTRUCTORS AND EQUIPMENT, INCORPORATED in FRANCO BUILDING, PENN STATE UNIV.-BERKS CAMPUS, READING, PA 19610 (NAICS 000000). OSHA activity number 300418274.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- B&W CONSTRUCTORS AND EQUIPMENT, INCORPORATED
- Site address
- FRANCO BUILDING, PENN STATE UNIV.-BERKS CAMPUS
- City
- READING
- State
- PA
- ZIP
- 19610
- Mailing
- 69 CONGO ROAD, GILBERTSVILLE, PA 19525
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1791
- Employees
- 2
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Sep 24, 2002
- Abate by
- Oct 21, 2002
- Penalty
- Initial $450 · Current $290 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards: (a)Franco Building, Penn State University, Berks Campus - An employee torched out clips for channels, approximately 12 feet above the ground, from the platform of a Genie S-40 self- propelled telescopic stick boom personnel lift. The employee did not use a personal fall arrest system while working from the lift, on or about September 4, 2002. Among other methods, one feasible and acceptable abatement method to correct this hazard includes using a personal fall arrest system, with the lanyard attached to the boom or basket of the personnel lift, as outlined in the American National Standards Institute safety standard for Boom-Supported Elevating Work Platforms (ANSI/SIA A92.5-1992). OR IN THE ALTERNATIVE 29 CFR 1926.453(b)(2)(v): Employee body harness and lanyard assembly was not attached to the boom or basket when working from an aerial lift. (a)Franco Building, Penn State University, Berks Campus - An employee torched out clips for channels, approximately 12 feet above the ground, from the platform of a Genie S-40 self- propelled telescopic stick boom personnel lift. The employee did not use a personal fall arrest system while working from the lift, on or about September 4, 2002. VERIFICATION REQUIRED
Recent events (2)
- — I (S) $290.00
- — Z (S) $450.00
1926.353 E02
- Issued
- Sep 24, 2002
- Abate by
- Oct 21, 2002
- Penalty
- Initial $450 · Current $295 Reduced
Recent events (2)
- — I (S) $295.00
- — Z (S) $450.00
More inspections in this industry (NAICS 000000)
More inspections in PA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 300418274.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.