GEORGETOWN, TX —
OSHA Inspection: ROGERS CONSTRUCTION COMPANY
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of ROGERS CONSTRUCTION COMPANY in 1/4 MILE OFF SUN CITY BLVD., GEORGETOWN, TX 78628 (NAICS 000000). OSHA activity number 300438546.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ROGERS CONSTRUCTION COMPANY
- Site address
- 1/4 MILE OFF SUN CITY BLVD.
- City
- GEORGETOWN
- State
- TX
- ZIP
- 78628
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- Yes
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1611
- Employees
- 12
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Dec 14, 1998
- Abate by
- Dec 18, 1998
- Penalty
- Initial $3,000 · Current $3,000
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: (a) the hazard of being struck by a moving D8R Caterpillar tractor. On or about 08-17- 98, an employee who was marking the route for his trenching machine, was run down and then run over by a Caterpillar tractor, about 1/4 mile from Sun City Blvd. Among other methods, one feasible and acceptable method to correct this hazard is to follow the instructions in the tractor's operations and maintenance manual. These are: (1) To make sure the area is free of personnel before starting the engine. (2) Clear all personnel from the machine and area before starting the engine. (3) Be satisfied that no one will be endangered before moving the machine. and/or in the alternative: 29 CFR 1926.20(b)(1) The employer did not maintain such programs as may be necessary to comply with this subpart: (a) The safety program was not revised annually and did not include guidelines for the safe operation of the D8R Caterpillar tractor. One method of abatement would be to follow the tractor manufacturer's operations manual, usually located in the pocket behind the operator's seat.
Recent events (2)
- — J (S) $3000.00
- — Z (S) $3000.00
1926.21 B02
- Issued
- Dec 14, 1998
- Abate by
- Dec 24, 1998
Recent events (2)
- — J (S)
- — Z (S)
More inspections at Rogers Construction Company
View Rogers Construction Company's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 300438546.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.