RAYMOND, IL —
OSHA Inspection: SORRELLS FARM SUPPLY, INC.
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of SORRELLS FARM SUPPLY, INC. in 210 E. BROAD, RAYMOND, IL 62560 (NAICS 000000). OSHA activity number 300611589.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- SORRELLS FARM SUPPLY, INC.
- Site address
- 210 E. BROAD
- City
- RAYMOND
- State
- IL
- ZIP
- 62560
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- Yes
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 4221
- Employees
- 9
- Ownership type
- A
Citations
5 citations on file for this inspection.
5(a)(1)
- Issued
- Aug 17, 2000
- Abate by
- Sep 13, 2000
- Penalty
- Initial $1,500 · Current $1,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of crushing injuries: On or about 7-5-2000,for the one person electric elevator (also known as a manlift) located near the grain dump, there was no type of guarding at the bottom elevator landing area to prevent an employee from being under the elevator as it descended. The bin floor elevator landing and the top floor elevator landing were also inadequately guarded to prevent an employee from falling into the evelator shaft when the elevator was not at that particular landing area. These conditions exposed the employee(s) to the hazards of being crushed-by or struck-by the descending elevator or falling into the elevator shaft. One method of abatement to correct this hazard is to guard the full height and width of the elevator openings as specified in the American National Standard Safety Code ANSI A17.1- 1993, Section 110, Rule 110.1. ***THIS ITEM REQUIRES A WRITTEN CERTIFICATION OF ABATEMENT***
5(a)(1)
- Issued
- Aug 17, 2000
- Abate by
- Sep 13, 2000
- Penalty
- Initial $1,500 · Current $1,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of falling out of the passenger elevator: On or about 7-5-2000 the one person electric elevator (also known as a manlift) located near the grain dump, the passenger car door electric interlock was located inside of the passenger car where it could easily be tampered with and actually by-passed to such a degree that the elevator could be operated with the elevator car door in the fully opened positon which would expose the passenger(employee) to a severe fall hazard. One method of abatement to correct this hazardous condition is to relocate the elelctric car door interlock so that it is not readily accessible from the inside of the car as described in the American National Standard Safety Code ANSI A17.1-1993 Section 111.5. ***THIS ITEM REQUIRES A WRITTEN CERTIFICATION OF ABATEMENT***
5(a)(1)
- Issued
- Aug 17, 2000
- Abate by
- Sep 13, 2000
- Penalty
- Initial $1,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of an unsafe passenger elevator: On or about 7-5-2000 for the one person electric elevator (also known as a manlift) located near the grain dump, there had not been any type of routine safety inspections performed by an inspector who meets the qualification requirements of the ANSI A17-1-1993 code, in the past year. This condition exposes employees using the elevator to the hazard of riding in a potentially unsafe passenger elevator. One method of abatement to correct this hazard is to have inspections and test of the elevator conducted as described in the American National Standard Safety Code ANSI A17.1-1993, Sections 1001 and 1002, Rule 1001.2 and 1002.2. ***THIS ITEM REQUIRES A WRITTEN CERTIFICATION OF ABATEMENT***
Recent events (2)
- — I (S)
- — Z (S) $1500.00
1910.23 C01
- Issued
- Aug 17, 2000
- Abate by
- Aug 23, 2000
- Penalty
- Initial $1,500 · Current $1,500
1910.307 C
- Issued
- Aug 17, 2000
- Abate by
- Aug 23, 2000
- Penalty
- Initial $750 · Current $750
More inspections in this industry (NAICS 000000)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 300611589.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.