WATERFORD, NY —
OSHA Inspection: NYS CANAL CORPORATION
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of NYS CANAL CORPORATION in 200 DAVIS AVE., WATERFORD, NY 12188 (NAICS 000000). OSHA activity number 301483095.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- NYS CANAL CORPORATION
- Site address
- 200 DAVIS AVE.
- City
- WATERFORD
- State
- NY
- ZIP
- 12188
- Mailing
- 200 SOUTHERN BLVD., ALBANY, NY 12209
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 4499
- Employees
- 80
- Ownership type
- C
Citations
5 citations on file for this inspection.
3A0001
- Issued
- Aug 6, 2002
- Abate by
- Aug 23, 2002
General-duty citation text
NYSLL Article 2, Section 27a(3)(a)(1): The employer did not furnish to each of its employees,employment and a place of employment which was free from recognized hazards that are causing or likely to cause death or serious physical harm to its employees and which will provide reasonable and adequate protection to the lives, safety or health of its employees. In applying this paragraph, fundamental distinctions between private and public sector employment have been recognized: Employees of the NYSTA Canal Corp are exposed to the hazard of electric shock and electrocution through the use of ungrounded electrical outlets during the course of maintenance activities aboard water craft. Reasonable and feasible abatement methods include, but are not limited to, assuring that the path to ground from outlets to the grounded service panel be permanent and continuous. (a) NYSTA Canal Corp-The duplex outlet on the port wall above the work bench of Derrick Boat #4 had an open ground. (b) NYSTA Canal Corp-The duplex outlet on the port wall in the galley og the tug boat Urger had an open ground. (c) NYSTA Canal Corp-The duplex outlet on the port wall in the pilot house of the tug boat Urger had an open ground.
3A0001
- Issued
- Aug 6, 2002
- Abate by
- Aug 23, 2002
General-duty citation text
NYSLL Article 2, Section 27a(3)(a)(1): The employer did not furnish to each of its employees, employment and a place of employment which was free from recognized hazards that are causing or likely to cause death or serious physical harm to its employees and which will provide reasonable and adequate protection to the lives, safety or health of its employees. In applying this paragraph, fundamental distinctions between private and public sector employment have been recognized: Employees of the NYSTA Canal Corp are exposed to the hazard of electric shock and electrocution during the course of performing maintenance tasks on outlets that have reverse polarity aboard water craft. Reasonable and feasible abatement methods include, but are not limited to, tracing the circuit wiring to determine where the faulty connection was made. (a) NYSTA Canal Corp-The duplex outlet on the aft wall in the galley of the tug boat Waterford had reverse polarity. (b) NYSTA Canal Corp-The GFCI outlet on the ceiling in the galley of the tug boat Waterford had reverse polarity. (c) NYSTA Canal Corp-The outlet on the forward wall in the bunk room of Derrick #4 had reverse polarity.
3A0001
- Issued
- Aug 6, 2002
- Abate by
- Aug 23, 2002
General-duty citation text
NYSLL Article 2, Section 27a(3)(a)(1): The employer did not furnish to each of its employees, employment and a place of employment which was free from recognized hazards that are causing or likely to cause death or serious physical harm to its employees and which will provide reasonable and adequate protection to the lives, safety or health of its employees. In applying this paragraph, fundamental distinctions between private and public sector employment havbe been recognized: NYSTA Canal Corp-Employees of the Canal Corp are exposed to electric shock and electrocution through incidental contact with damaged electrical cable aboard water craft. Reasonable and feasible abatement methods include, but are not limited to, replacing the damaged cable. (a) NYSTA Canal Corp-The electric cable in the engine room of Derrick Boat #4 running from the 120 volt generator to a wall panel had its insulation damaged and repaired with electrical tape, resulting in the possible exposure of live parts.
1910.303 G02 I
- Issued
- Aug 6, 2002
- Abate by
- Aug 9, 2002
1910.303 B01 II
- Issued
- Aug 6, 2002
- Abate by
- Aug 23, 2002
More inspections at NYS Canal Corporation
View NYS Canal Corporation's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 301483095.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.