EL PASO, TX —
OSHA Inspection: WORSHAM STEEL CO
Unprogrammed Related inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Related safety inspection of WORSHAM STEEL CO in 14001 MONTANA (16 MILES EAST OF EL PASO), EL PASO, TX 79907 (NAICS 000000). OSHA activity number 301567673.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- WORSHAM STEEL CO
- Site address
- 14001 MONTANA (16 MILES EAST OF EL PASO)
- City
- EL PASO
- State
- TX
- ZIP
- 79907
- Mailing
- BOX 26214, EL PASO, TX 79926
What kind of inspection was it?
- Inspection type
- Unprogrammed Related (G)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- Yes
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3441
- Employees
- 28
- Ownership type
- A
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Sep 2, 1998
- Abate by
- Sep 8, 1998
- Penalty
- Initial $3,000 · Current $3,000
General-duty citation text
Section 5a()(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or were likely to cause death or serious physical harm to employees in that employees were exposed to: A contract employee working for Bowen Arrow, reported to Worsham Steel Co, located at 14001 Montana Ave, El Paso,Tx on or about April 6,1998 to check on an overhead bridge crane that was reported to Bowen Arrow as not operating properly. The Bowen Arrow employee working with Worsham Steel foreman and forklift operator, attached a metal cage to a forklift and raised the Bowen Arrow Employee up to the Bridge crane to check on the crane's brake system. While the Bowen Arrow employee was working approximately 30 feet above ground level, the forklift operator left the forklift in the raise position with the worker still on the man lift cage. This condition exposed the employee on the cage to fall hazards and caught between hazards. Feasible and acceptable methods to correct this hazard include, but are not limited to the following: a. Establish written procedures covered in ANSI B56.1-1975, which states, there shall be an operator in the control position on the truck. b. Implement employee training on company written procedures
More inspections at Worsham Steel CO
View Worsham Steel CO's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 301567673.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.