CAROLINA, PR —
OSHA Inspection: UBARRI CONSTRUCTION CORP.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of UBARRI CONSTRUCTION CORP. in PROYECTO PASEO DEL REY CARR 8860 KM 3.1 BO MARTIN, CAROLINA, PR 00986 (NAICS 238110). OSHA activity number 301711222.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- UBARRI CONSTRUCTION CORP.
- Site address
- PROYECTO PASEO DEL REY CARR 8860 KM 3.1 BO MARTIN
- City
- CAROLINA
- State
- PR
- ZIP
- 00986
- Mailing
- #856 AVE SAN PATRICIO LAS LOMAS, SAN JUAN, PR 00920
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238110
- SIC code (legacy)
- 1771
- Employees
- 40
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
4 citations on file for this inspection.
1926.501 B01
- Issued
- Mar 11, 2004
- Abate by
- Mar 16, 2004
- Penalty
- Initial $700 · Current $700
1926.701 B
- Issued
- Mar 11, 2004
- Abate by
- Mar 16, 2004
- Penalty
- Initial $875 · Current $875
6A0001
- Issued
- Mar 11, 2004
- Abate by
- Mar 16, 2004
- Penalty
- Initial $350 · Current $350
General-duty citation text
Section 6(a) of the Puerto Rico Occupational Safety and Health Act: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or physical harm to employees in that employees were exposed to: Seccion 6(a) de la Ley de Seguridad y Salud en el Trabajo de Puerto Rico: El patrono no proveyo empleo y un sitio de empleo libre de riesgos reconocidos que esten causando o que puedan causar muerte o dano fisico a los empleados, por cuanto empleados estaban expuestos a: The hazard is employees being struck by the load. The dead end side of the crane wire rope on a wedge socket type termination at the headache ball was attached to the live line with a wire rope clip. The clip will transfer the load to the dead end side of the wire rope causing damage to the live side of the wire rope and/or cause instability in the crane hoist system and load. Employees were placing and removing form work molds from the second floor, of the Southeast, type A building of the Costamar Beach Village West, located on Municipal Street, Mediania Alta, Loiza, with a crane, make Lima, model 700TC, serial number 4A0189490, type motor crane, with a capacity of 75 tons, located at the rear of the building. Among other methods, one feasible and acceptable abatement method to correct is to remove the wire clip from the live line and place it on the dead end side, check to see if the live line has been damaged, and if so, replace the wire rope. El riesgo es que los empleados sean impactados por la carga. En la terminacion de casquillo de cuna, ubicado en el gancho con peso de la grua, el cable terminal que sobre sale estaba amarrado junto a la linea principal del cable de alambre de la grua con una presilla para cable de alambre. El efecto es que la presilla transfiere la carga al cable terminal causando dano a la linea principal y o causando inestabilidad en el sistema de izar de la grua y en la carga. Los empleados estaban instalando y removiendo los moldes de las formaletas del segundo piso, del edificio tipo A del lado sur del proyecto Costamar Beach Village West, ubicado en la calle Municipal, Mediania Alta, Loiza, con una grua, marca Lima, modelo 700TC, numero de serie 4A189490, tipo grua de motor, con capacidad de 75 toneladas, ubicada en la parte trasera del edificio. Entre otros metodos aceptables para corregir, uno viable y aceptable es remover la presilla y reponerla en el cable terminal, revisar por dano en la linea principal, y si hay dano reemplazar el cable de alambre.
1926.550 A04
- Issued
- Mar 11, 2004
- Abate by
- Mar 16, 2004
More inspections at Ubarri Construction Corp.
View Ubarri Construction Corp.'s full OSHA safety record →
More inspections in this industry (NAICS 238110)
More inspections in PR
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 301711222.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.