BURLINGTON, NC —
OSHA Inspection: CULP, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CULP, INC. in 1406 SOUTH MEBANE STREET, BURLINGTON, NC 27216 (NAICS 000000). OSHA activity number 301962460.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CULP, INC.
- Site address
- 1406 SOUTH MEBANE STREET
- City
- BURLINGTON
- State
- NC
- ZIP
- 27216
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 2262
- Employees
- 279
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
24 citations on file for this inspection.
95012901
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $1,375 · Current $825 Reduced
General-duty citation text
North Carolina General Statue 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees condition of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to structural collapse of underhung hoisting equipment:(REF ASME/ANSI B30.16, Section 16- 1.3.2, 1.2.1) a)plant, battery charging area - one-half ton rated underslung hoist, unknown make and model, was used to lift a 1483 pound battery and lifting yoke from an unrated structure. Among other methods, one feasible and acceptable method for correcting this hazard would be to install a greater capacity hoist appropriate to the loads that are required to be lifted, installed on an approved design structure.
Recent events (2)
- — I (S) $825.00
- — Z (S) $1375.00
7F0102
- Issued
- Jan 28, 1998
- Abate by
- Feb 15, 1998
- Penalty
- Initial $825 · Current $485 Reduced
Recent events (2)
- — I (S) $485.00
- — Z (S) $825.00
1910.147 C04 I
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $1,375 · Current $825 Reduced
Recent events (2)
- — I (S) $825.00
- — Z (S) $1375.00
1910.184 D
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $1,375 · Current $825 Reduced
Recent events (2)
- — I (S) $825.00
- — Z (S) $1375.00
1910.184 E04
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.213 B03
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $413 · Current $250 Reduced
Recent events (2)
- — I (S) $250.00
- — Z (S) $413.00
1910.213 H04
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $413 · Current $250 Reduced
Recent events (2)
- — I (S) $250.00
- — Z (S) $413.00
1910.213 I01
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $413 · Current $250 Reduced
Recent events (2)
- — I (S) $250.00
- — Z (S) $413.00
1910.219 B02
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
- Penalty
- Initial $1,375 · Current $825 Reduced
Recent events (2)
- — I (S) $825.00
- — Z (S) $1375.00
7F0102
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
7F0102
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.22 A01
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.22 B02
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.22 D01
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.23 D01 IV
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.38 A02 I
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.151 C
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.215 B09
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.219 C04 I
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.253 B02 IV
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.303 E
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.303 F
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.305 B01
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
1910.305 G01 III
- Issued
- Jan 28, 1998
- Abate by
- Feb 3, 1998
More inspections at Culp, INC.
View Culp, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 301962460.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.