DURHAM, NC —
OSHA Inspection: ALLSTATE MECANICAL SUBCONTRACTORS, INC.
Unprogrammed Related inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Related safety inspection of ALLSTATE MECANICAL SUBCONTRACTORS, INC. in 2000 AVONDALE, DURHAM, NC 27704 (NAICS 000000). OSHA activity number 301963146.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ALLSTATE MECANICAL SUBCONTRACTORS, INC.
- Site address
- 2000 AVONDALE
- City
- DURHAM
- State
- NC
- ZIP
- 27704
- Mailing
- 161 VISTA LANE, PELLCITY, AL 35125
What kind of inspection was it?
- Inspection type
- Unprogrammed Related (G)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1711
- Employees
- 4
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
3 citations on file for this inspection.
95012901
- Issued
- Feb 4, 1998
- Abate by
- Feb 9, 1998
- Penalty
- Initial $350 · Current $350
General-duty citation text
North Carolina General Statue 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees condition of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to a fall to a lower elevation: a)Southeast Corner of Winn-Dixie site - two employees using a Strato-Lift and Boom aerial lift were working while standing on the top rails 10' 2" above the floor and did not have a firm footing on the platform floor and was not wearing any fall arrest equipment (ref. ANSI/SIA A92.6-1990, 7-11.1). One feasible and acceptable abatement method, among others, to correct this hazard is to always park the scissors lift in a position relative to the work to be performed so that the employee can stand within the confines of the platform to perform the work.rm
1926.20 B03
- Issued
- Feb 4, 1998
- Abate by
- Feb 22, 1998
1926.454 A
- Issued
- Feb 4, 1998
- Abate by
- Feb 9, 1998
More inspections in this industry (NAICS 000000)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 301963146.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.