ALFRED, TX —
OSHA Inspection: CORPUS CHRISTI DRILLING & WORKOVER L.L.C. RIG #5
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of CORPUS CHRISTI DRILLING & WORKOVER L.L.C. RIG #5 in 2 MI. E. HWY 359 ON FM 1539 1/4 MI. N., ALFRED, TX 78372 (NAICS 000000). OSHA activity number 302105820.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CORPUS CHRISTI DRILLING & WORKOVER L.L.C. RIG #5
- Site address
- 2 MI. E. HWY 359 ON FM 1539 1/4 MI. N.
- City
- ALFRED
- State
- TX
- ZIP
- 78372
- Mailing
- 311 SARATOGA, CORPUS CHRISTI, TX 78417
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1381
- Employees
- 12
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
17 citations on file for this inspection.
5(a)(1)
- Issued
- Aug 30, 2000
- Abate by
- Sep 3, 2000
- Penalty
- Initial $2,500 · Current $2,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to a fire or explosion hazard: Employee was exposed to the hazard of fire and explosion due to the improper rigging of the Geronimo Emergency Escape and installation of the Geronimo Emergency Escape Device on the Geronimo Emergency Escape Line due to: a.The Geronimo Emergency Escape Device and Line were installed next to the monkey board 65 feet above the ground with the line running down the west derrick leg with no safe egress. b.The Emergency Escape Line was not anchored/staked out as recommended by the manufacturer Geronimo Manufacturing, Inc. This occurred on July 10,2000 on Corpus Christi Drilling & Workover L.L.C. Rig #5. Among other methods for abatement, one feasible and acceptable abatement method to correct this hazard would be installation of a properly rigged and secured emergency descent device or other satisfactory auxiliary means of egress, such as specified in Section 5, Sub-Section 5.7, Paragraph 5.7.1 of American Petroleum Institute (API) RP 54-92, Page 12. Essential elements of this procedure would include: 1.Staking out securely anchored one-half inch wire rope line to the derrick or mast so as to provide a ready and convenient means of escape from the derrick mans's working platform. 2.The escape line route is to be kept clear of obstructions. 3.A safety device is to be provided to permit fast emergency exit from the derrick man's working platform to a safe place. 4.The tension on the escape line is to be periodically checked and adjusted to assure a safe landing and to allow the derrick man to stop 20 to 25 feet from the anchor point. 5.The ground anchor point of the escape line is to be located a minimum lateral distance from the derrick or mast equal to the height above ground level to the point where the escape line is fastened.
5(a)(1)
- Issued
- Aug 30, 2000
- Abate by
- Sep 3, 2000
- Penalty
- Initial $2,500 · Current $2,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to a collapsed mast (derrick) hazard: The hazard of collapsed mast (derrick) of a drilling rig resulting from failure to install wire rope guylines with correctly installed Crosby clips on all four side of the rig as recommended by the manufacturer's specifications for the safe guying of the mast to ensure adequate anchorage in the following: a.Four guylines incorrectly installed Crosby clips. b.Geronimo emergency Escape Line incorrectly installed Crosby clips. c.Catline on the rig floor incorrectly installed Crosby clips. This occurred on July 12, 2000 on Corpus Christi Drilling & Workover L.L.C. Rig #5. Among other methods of abatement, one feasible and acceptable abatement method to correct this hazard would be installation of a properly secured guylines as specified in the American Petroleum Institute Second edition, paragraph 3.14 of Spec 4e and American Petroleum Institute Standard 4d sixth edition paragraph 3.4 and American Petroleum Standard 4f, appendix c16, first edition May 01,1985.Essential elements of this procedures would include: 1.Hand screwed in auger anchors into the soil according to the Manufacturer's recommended specifications. 2.Wire rope guylines properly secured to the raised portion of the auger anchor. 3.Also correctly install and properly secure the Crosby clips to the ends of the wire rope guylines.
1910.23 A01
- Issued
- Aug 30, 2000
- Abate by
- Sep 3, 2000
- Penalty
- Initial $525 · Current $525
1910.23 C01
- Issued
- Aug 30, 2000
- Abate by
- Sep 3, 2000
- Penalty
- Initial $525 · Current $525
1910.133 A01
- Issued
- Aug 30, 2000
- Abate by
- Sep 4, 2000
- Penalty
- Initial $1,225 · Current $1,225
1910.138 A
- Issued
- Aug 30, 2000
- Abate by
- Sep 4, 2000
- Penalty
- Initial $1,225 · Current $1,225
1910.151 C
- Issued
- Aug 30, 2000
- Abate by
- Sep 4, 2000
- Penalty
- Initial $2,500 · Current $2,500
1910.157 C04
- Issued
- Aug 30, 2000
- Abate by
- Sep 4, 2000
- Penalty
- Initial $525 · Current $525
1910.219 D01
- Issued
- Aug 30, 2000
- Abate by
- Sep 4, 2000
- Penalty
- Initial $700 · Current $700
1910.219 E01 I
- Issued
- Aug 30, 2000
- Abate by
- Sep 4, 2000
1910.304 F04
- Issued
- Aug 30, 2000
- Abate by
- Sep 5, 2000
- Penalty
- Initial $700 · Current $700
1910.1200 E01
- Issued
- Aug 30, 2000
- Abate by
- Sep 7, 2000
- Penalty
- Initial $525 · Current $525
1910.1200 G01
- Issued
- Aug 30, 2000
- Abate by
- Sep 7, 2000
1910.1200 H01
- Issued
- Aug 30, 2000
- Abate by
- Sep 12, 2000
1904.2 A
- Issued
- Aug 30, 2000
- Abate by
- Sep 7, 2000
1910.151 B
- Issued
- Aug 30, 2000
- Abate by
- Sep 7, 2000
1910.184 E01
- Issued
- Aug 30, 2000
- Abate by
- Sep 7, 2000
More inspections in this industry (NAICS 000000)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 302105820.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.