Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,124Inspections Most recent open 2026-08-25 Last loaded 2026-08-28

OSHA Inspection: D & L INTERIORS

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of D & L INTERIORS in RT 96 , VICTOR'S LANDING, VICTOR, NY 14564 (NAICS 000000). OSHA activity number 302698626.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch D & L Interiors for free Get an email when a new federal OSHA severe-injury report for D & L Interiors is published. One employer, no account, unsubscribe in one click.
Establishment
D & L INTERIORS
Site address
RT 96 , VICTOR'S LANDING
City
VICTOR
State
NY
ZIP
14564
Mailing
PO BOX 60, PIFFARD, NY 14533
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (N)
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
1542
Employees
5
Ownership type
Private (A)

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 03 1 instance 1 exposed
Issued
Jun 20, 2001
Abate by
Jun 25, 2001
Penalty
Initial $375 · Current $375
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employmnent and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to a FALL HAZARD:
a)On or about 06/13/01, an employee was observed working from a self-
propelled Elevating Work Platform (ADMAR scissors lift) at a height of
approximately 20 feet. The employee was standing on the top hand rail of
the
lift performing roof installation:
Among other methods, several feasible and acceptable abatement methods to
correct
this hazard are to:
1.Ensure personnel maintain a firm footing on the platform floor while
working
from the platform.
2.Instruct all personnel operating and supervising work in an aerial
platform
in the compliance procedures of ANSI A92.6-1990,Self-Propelled Elevating
Work Platforms.,Self-Propelled

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 302698626.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.