Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,124Inspections Most recent open 2026-08-25 Last loaded 2026-08-28

OSHA Inspection: A. CAMPO GENERAL CONTRACTOR

Accident-driven inspection · Safety discipline

On , OSHA opened an accident-driven safety inspection of A. CAMPO GENERAL CONTRACTOR in BETWEEN # 6 & 7 MOUNTAIN LANE, HOLMDEL, NJ 07733 (NAICS 000000). OSHA activity number 302710629.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch A. Campo General Contractor for free Get an email when a new federal OSHA severe-injury report for A. Campo General Contractor is published. One employer, no account, unsubscribe in one click.
Site address
BETWEEN # 6 & 7 MOUNTAIN LANE
City
HOLMDEL
State
NJ
ZIP
07733
Mailing
CRANBURY ROAD,DRAWER 608, FARMINGDALE, NJ 07727
Inspection type
Accident-driven (A)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (N)
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
1629
Employees
8
Ownership type
Private (A)

2 citations on file for this inspection.

5(a)(1)

Deleted Serious Gravity 10 1 instance 1 exposed
Issued
Dec 23, 1999
Abate by
May 11, 2000
Penalty
Initial $1,500
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The
employer did not
furnish employment and a place of employment which are free from
recognized hazards that
were likely to cause death or serious physical harm to employees in that
an employee was
exposed to hazards of being struck by or run over:
a) Mountain Rd. - An employee was subject to the hazard of being struck by
or run
over due to faulty equipment of a 1986 Mack tractor and a 1995 Rogers
trailer due to
the following conditions: (a) The tractors' emergency brake system failed,
(b) the
wheels of the vehicle combination were not chocked, and (3) the vehicle
combination
was not parked on level ground. On or about 06/25/99.
Among other methods, feasible and acceptable abatement methods to correct
the
hazards are to:
1) Assure that parts and accessories are in safe operating condition as
required in 49
CFR 396.3A1: Parts and accessories shall be in safe operating condition at
all times.
These include those specified in Part 393 of this subchapter and any other
additional
parts and accessories which may effect safety of operation, including but
not limited
to, frame and frame assemblies, suspension systems, axles and attaching
parts, wheels
and rims, and steering systems.
2) Develop and implement a policy to assure that wheel chocks be used when
connecting and/or disconnecting trailers from tractors and while
performing service
and maintenance.
3) Develop and implement a policy that assures employees follow the trailer
manufacturer's instruction to "Locate the trailer on level ground with a
grade no
greater than 3 percent, then set the brakes on the tractor".
NOTE: ABATEMENT DOCUMENTATION REQUIRED FOR THIS ITEM.
See page 2,"Notification of Corrective Action" for instructions.
Recent events (2)
  • · F (S)
  • · Z (S) $1500.00

1926.21 B02

Other-than-serious Gravity 10 1 instance 1 exposed
Issued
Dec 23, 1999
Abate by
Feb 11, 2000
Penalty
Initial $1,500
Recent events (2)
  • · F (O)
  • · Z (S) $1500.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 302710629.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.