BRONX, NY —
OSHA Inspection: HUNTS POINT TERMINAL PRODUCE COOP. ASS., INC.
Unprogrammed Related inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Related safety inspection of HUNTS POINT TERMINAL PRODUCE COOP. ASS., INC. in NYC TERMINAL BUILDING A, RM 2A, BRONX, NY 10474 (NAICS 000000). OSHA activity number 302805148.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HUNTS POINT TERMINAL PRODUCE COOP. ASS., INC.
- Site address
- NYC TERMINAL BUILDING A, RM 2A
- City
- BRONX
- State
- NY
- ZIP
- 10474
What kind of inspection was it?
- Inspection type
- Unprogrammed Related (G)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 8742
- Employees
- 10
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Aug 24, 2000
- Abate by
- Feb 28, 2001
- Penalty
- Initial $525 · Current $500 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards when cleaning roofs: LOCATION: B-3 Module Bronx, NY 10474 Hunts Point Terminal Market on or about 6/27/00, B-3 Module a) The employees went to the roof to clean both the upper and lower levels. The lower level was approximately 14' above the ground. The roof was not protected with standard guardrail nor was any other method of fall protection used. AMONG OTHER METHODS, ONE FEASIBLE AND ACCEPTABLE ABATEMENT METHOD TO CORRECT THIS HAZARD IS TO IMPLEMENT THE FOLLOWING: 1) install guardrail around the perimeter of the upper and lower levels of the roof. NOTE: The employer is required to submit abatement certification for this item in accordance with 29 CFR 1903.19.ce
Recent events (2)
- — F (S) $500.00
- — Z (S) $525.00
More inspections in this industry (NAICS 000000)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 302805148.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.