CHARLOTTE, NC ·
OSHA Inspection: OXENDINE CONSTRUCTION
Programmed Related inspection · Safety discipline
At a glance
On , OSHA opened a programmed Related safety inspection of OXENDINE CONSTRUCTION in 1500 SUTHER ROAD, CHARLOTTE, NC 28213 (NAICS 000000). OSHA activity number 303630784.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- OXENDINE CONSTRUCTION
- Site address
- 1500 SUTHER ROAD
- City
- CHARLOTTE
- State
- NC
- ZIP
- 28213
- Mailing
- 5054 OLD LOWERY ROAD, SHANNON, NC 28386
What kind of inspection was it?
- Inspection type
- Programmed Related (I)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1761
- Employees
- 5
- Ownership type
- Private (A)
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
95012901
- Issued
- May 30, 2000
- Abate by
- Jun 5, 2000
- Penalty
- Initial $500 · Current $500
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees, conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that employees were exposed to: a)a fork lift truck was being used to lift workers to and from the North side of the roof of a church sanctuary, approximately 14 feet above the ground, on a 4 foot by 8 foot by 1/2 inch thick sheet of plywood which was not secured to the lift truck, and which had no standard rails. Among other methods, one feasible and acceptable abatement method to correct this hazard would be to construct a platform designed to raise and lower workers which could be secured to the fork lift truck, and which would be equipped with a standard rail.ard
1926.501 B11
- Issued
- May 30, 2000
- Abate by
- Jun 5, 2000
- Penalty
- Initial $500 · Current $500
More inspections in this industry (NAICS 000000)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 303630784.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.