Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,191,473Inspections Most recent open 2026-07-28 Last loaded 2026-07-31

OSHA Inspection: FRITZ CHEMICAL CO. PET PRODUCTS DIVISION

Referral inspection · Health discipline

On , OSHA opened a referral health inspection of FRITZ CHEMICAL CO. PET PRODUCTS DIVISION in 230 N. SAM HOUSTON RD., MESQUITE, TX 75149 (NAICS 000000). OSHA activity number 303907653.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Fritz Chemical CO. PET Products Division — free Get an email when a new federal OSHA severe-injury report for Fritz Chemical CO. PET Products Division is published. One employer, no account, unsubscribe in one click.
Site address
230 N. SAM HOUSTON RD.
City
MESQUITE
State
TX
ZIP
75149
Mailing
230 SAM HOUSTON RD., MESQUITE, TX 75149
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Health
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
000000
SIC code (legacy)
5169
Employees
34
Ownership type
A
Industry flags
Manufacturing health.

2 citations on file for this inspection.

5(a)(1)

Serious Gravity 03 1 instance 7 exposed
Issued
May 24, 2001
Abate by
Jun 22, 2001
Penalty
Initial $1,375 · Current $825 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish a place of employment which were free from recognized hazards that
were causing or
likely to cause death or serious physical harm to employees: fire and
explosion
The following requirements established by the National Fire Protection
Association must be met
when handling or processing combustible dust in order to minimize the risk
of fire and explosion
in the Glatt System Warehouse:
1. A vent in a enclosure (vessel) must be provided to limit the maximum
pressure resulting from
deflagration. The enclosure or vessel is referred to the entire Glatt
system (Glatt machine, duct
system, dust collector system and dust waste container).  The enclosure
must be designed to
withstand fullforce of the deflageration.
REFERENCE:  National Fire Codes 1984, section 68, paragraph 3-1.1
2. The dust collector can be located inside a building only if one of the
following
exceptions is
met:
Exception 1:  Dust collector is located adjacent to an exterior wall, is
vented to the outside
through straight ducts not exceeding 10 feet(3 meters) in length, and have
explosion vents be
located adjacent to an exterior wall, and the dust collector is vented to
the outside through
straight ducts not exceeding 10 ft in length, and have explosion vent.
Exception 2:  Dust collector is protected with an explosion suppression
system.
REFERENCE:  National Fire Codes 1984, section 654, paragraph 4-1.3
3. All machines and equipment including duct work, storage bins, and
permanently installed and
portable vacuum cleaning systems shall be bonded and grounded.
REFERENCE:  National Fire Codes 1984, section 654, paragraph 5-5.2.4
Recent events (2)
  • — I (S) $825.00
  • — Z (S) $1375.00

1910.151 C

Serious Gravity 01 1 instance 1 exposed
Issued
May 24, 2001
Abate by
Jun 6, 2001
Penalty
Initial $675 · Current $405 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish a place of employment which were free from recognized hazards that
were causing or
likely to cause death or serious physical harm to employees.
The following requirements established by the National Fire Protection
Association must be met
when handling or processing combustible dust in order to minimize the risk
of fire and explosion
in the Glatt System Warehouse:
1. A vent in a enclosure (vessel) must be provided to limit the maximum
pressure
resulting from
deflagration. The enclosure or vessel is referred to the entire Glatt
system (Glatt machine, duct
system, dust collector system and dust waste container).  The enclosure
must be designed to
withstand fullforce of the deflageration.
REFERENCE:  National Fire Codes 1984, section 68, paragraph 3-1.1
2. The dust collector can be located inside a building only if one of the
following exceptions is
met:
Exception 1:  Dust collector is located adjacent to an exterior wall, is
vented to the outside
through straight ducts not exceeding 10 feet(3 meters) in length, and have
explosion vents be
located adjacent to an exterior wall, and the dust collector is vented to
the outside through
straight ducts not exceeding 10 ft in length, and have explosion vent.
Exception 2:  Dust collector is protected with an explosion suppression
system.
REFERENCE:  National Fire Codes 1984, section 654, paragraph 4-1.3
3. All machines and equipment including duct work, storage bins, and
permanently
installed and
portable vacuum cleaning systems shall be bonded and grounded.
REFERENCE:  National Fire Codes 1984, section 654, paragraph 5-5.2.4
Recent events (2)
  • — I (S) $405.00
  • — Z (S) $675.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 303907653.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.