WADESBORO, NC ·
OSHA Inspection: U-LINER MID-AMERICA, INC. DBA CSR HYDRO CONDUIT
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of U-LINER MID-AMERICA, INC. DBA CSR HYDRO CONDUIT in 604 MCLAURIN ST., WADESBORO, NC 28170 (NAICS 000000). OSHA activity number 304087661.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- U-LINER MID-AMERICA, INC. DBA CSR HYDRO CONDUIT
- Site address
- 604 MCLAURIN ST.
- City
- WADESBORO
- State
- NC
- ZIP
- 28170
- Mailing
- PO BOX 1138, YOUNGSVILLE, NC 27596
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1623
- Employees
- 14
- Ownership type
- Private (A)
- Industry flags
- Construction health.
Citations
4 citations on file for this inspection.
95012901
- Issued
- Jan 10, 2001
- Abate by
- Jan 16, 2001
- Penalty
- Initial $1,050 · Current $1,050
General-duty citation text
North Carolina General Statute 95-129(1) of the Occupational Safety and Health Act of North Carolina: The employer did not furnish to each of his employees conditions of employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees: a)jobsite, U-Liner Mid-America, Inc. dba CSR Hydro Conduit failed to develop and implement a written confined space program for employees who were entering sewer and water line manholes, failed to perform pre-entry confined space air monitoring for oxygen, toxic gas and flammable gas content with a calibrated direct reading instrument, failed to perform continuous testing of the confined space atmosphere to determine if an oxygen deficient, toxic gas and/or flammable environment would arise during operations, failed to complete confined space entry permits, and failed to implement procedures for and provide an attendant/standby person at the confined space entrance opening. Feasible and acceptable methods to correct this hazard include, but are not limited to: 1.Develop, implement and enforce a permit-required confined space program in accordance with 29 CFR 1910.146 North Carolina Occupational Safety and Health Standard for General Industry. 2.Develop, implement and enforce a confined space program in accordance with American National Standards Institute (ANSI) Z117.1-1995. 3.Perform atmospheric testing or monitoring of all confined spaces such as, but not limited to, manholes with a calibrated direct reading instrument for oxygen content, flammable gases and toxic air contaminants in accordance with the instrument manufacturer's recommendations. 4.Perform atmospheric testing or monitoring of all confined spaces such as, but not limited to, manholes continuously while employees are in confined spaces. 5.The completion of confined space entry permits for each entry into a confined space which certifies that all existing and potential hazards have been evaluated by a qualified person and necessary protective measures have been taken to ensure the safety of each employee. 6.Provide an available attendant at the entry of the confined space to monitor conditions and implement emergency rescue procedures if necessary.
1926.21 B06 I
- Issued
- Jan 10, 2001
- Abate by
- Jan 16, 2001
1926.103 C02 I
- Issued
- Jan 10, 2001
- Abate by
- Jan 16, 2001
1926.103 C02 II
- Issued
- Jan 10, 2001
- Abate by
- Jan 16, 2001
More inspections in this industry (NAICS 000000)
More inspections in NC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 304087661.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.