STE. GENEVIEVE, MO ·
OSHA Inspection: READY MIX CONCRETE INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of READY MIX CONCRETE INC. in 10949 INDUSTRIAL DRIVE, STE. GENEVIEVE, MO 63670 (NAICS 000000). OSHA activity number 304325350.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- READY MIX CONCRETE INC.
- Site address
- 10949 INDUSTRIAL DRIVE
- City
- STE. GENEVIEVE
- State
- MO
- ZIP
- 63670
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Union (Y)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3273
- Employees
- 6
- Ownership type
- Private (A)
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 21, 2002
- Abate by
- Apr 9, 2002
- Penalty
- Initial $300 · Current $150 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: Employees are exposed to a fall hazard of approximately 8 feet once they access the work platforms located at the rear of the cement mixer trucks. The entrance to the work platform is left unguarded. Among other feasible and acceptable methods to correct this hazard would be to: Install a chain or other mechanically strong material across the entrance opening to the work platform. This chain or other mechanically strong material would be left in the open position while employees access the work platform. Once the employees gain access to the work platform, the chain or other mechanically strong material would be secured in the closed position. Another feasible method for guarding this open side would be to; install a swinging gate which could be secured in the open position while employees access the work platform. Once employees gain access to the work platform, the swinging gate can be secured in the closed position. Abatement certification and abatement documentation is required for this violation. The documentation should include written verification of abatement, applicable measurements or monitoring results, and photographs or videos which you believe will be helpful. The abatement certification sheet is enclosed with the citations(s).
Recent events (2)
- · I (S) $150.00
- · Z (S) $300.00
1910.303 G02 I
- Issued
- Feb 21, 2002
- Abate by
- Apr 9, 2002
- Penalty
- Initial $300 · Current $150 Reduced
Recent events (2)
- · I (S) $150.00
- · Z (S) $300.00
1910.147 C04 I
- Issued
- Feb 21, 2002
- Abate by
- Apr 9, 2002
Recent events (2)
- · I (O)
- · Z (O)
More inspections at Ready MIX Concrete INC.
View Ready MIX Concrete INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in MO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 304325350.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.