MORRIS TOWNSHIP, NJ —
OSHA Inspection: MORRIS TOWNSHIP DPW GARAGE
Special Programs inspection · Safety discipline
At a glance
On , OSHA opened a special Programs safety inspection of MORRIS TOWNSHIP DPW GARAGE in JANE WAY, MORRIS TOWNSHIP, NJ 07961 (NAICS 000000). OSHA activity number 304370745.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MORRIS TOWNSHIP DPW GARAGE
- Site address
- JANE WAY
- City
- MORRIS TOWNSHIP
- State
- NJ
- ZIP
- 07961
- Mailing
- MORRIS TOWNSHIP MUNICIPAL BUILDING, CONVENT STATION, NJ 07961
What kind of inspection was it?
- Inspection type
- Special Programs (K)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 4789
- Employees
- 50
- Ownership type
- B
Citations
15 citations on file for this inspection.
1910.38 A01
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.212 A01
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.212 A03 II
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.212 A03 II
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.212 B
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.215 A04
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.215 B09
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.215 D03
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.219 C02 I
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.219 E01 I
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.254 D09 III
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.266 I03 II
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.266 I07
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
1910.303 B01 III
- Issued
- May 2, 2002
- Abate by
- May 7, 2002
5(a)(1)
- Issued
- May 2, 2002
- Abate by
- Jun 17, 2002
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: Hazard of crushing injury/death when entering/ exiting through the powered overhead doors. LOC: Garage, Powered Overhead Doors Employees were exposed to ahazard of crushing injury/death when entering/ exiting through theoverheaddoors. COMMENT:Amongmethods of abatement would include (as set forth in ANSI standard A156.8) and the following: 1. A constant pressure actuation switch. This would always be operated in sight of the door so that it could be released and manually reversed if an obstruction was hit. 2. Installation of a reversing edge switch. This would allow an automatic closing control out of sight of the door, but would immediately reverse the direction of the door upon striking an obstruction. A variation to this option would be the use of photoelectric cells that would reverse the door when an obstruction was encountered by the beam. OR 3. A three-button control switch. If the following conditions are also met: (a) It is provided with a permanent placard adjacent to the switch with the following warning letters at least 1/4" high: WARNING TO PREVENT ENTRAPMENT DO NOT START DOOR DOWNWARD UNLESS DOORWAY IS CLEAR (b) The control station and placard are located within sight of the doorway. (c) Automatic closing controls are not also installed. (d) Operator must remain at the control station and observe the door until the door is fully closed.
More inspections at Morris Township DPW Garage
View Morris Township DPW Garage's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 304370745.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.