NORTHFIELD, NJ —
OSHA Inspection: ATLANTIC COUNTY FLEET MAINTENANCE FACILITY
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ATLANTIC COUNTY FLEET MAINTENANCE FACILITY in ROUTE 9 AND DOLPHIN AVENUE, NORTHFIELD, NJ 08225 (NAICS 000000). OSHA activity number 304370836.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ATLANTIC COUNTY FLEET MAINTENANCE FACILITY
- Site address
- ROUTE 9 AND DOLPHIN AVENUE
- City
- NORTHFIELD
- State
- NJ
- ZIP
- 08225
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 9199
- Employees
- 15
- Ownership type
- B
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Mar 20, 2002
- Abate by
- May 6, 2002
General-duty citation text
29 CFR 1910.5(a)(1): The employer did not provide the employees with a place of employment which was free from a recognized hazard. LOC: Fleet Maintenance Garage, Six (6) Powered Overhead Doors The overhead doors were equipped with 3 button switches that were not constant pressure switches, thereby causing or likely to cause death or serious physical harm to employees by crushing. Reference: ANSI-A156.8 COMMENT: Feasible methods of abatement could include: 1) A constant pressure actuation switch. This would always be operated in sight of the door so that it could be released and manually reversed if an obstruction was hit. 2) Installation of a reversing edge switch. This would allow an automatic closing control out of sight of the door, but would immediately reverse the direction of the door upon striking an obstruction. A variation to this option would be the use of photoelectric cells that would reverse the door when an obstruction was encountered by the beam. 3) A three button control switch. If the following following conditions are also met: a) It is provided with a permanent placard adjacent to the switch with the following warning letters at least 1/4" high. WARNING -TO PREVENT ENTRAPMENT DO NOT START DOOR DOWNWARD UNLESS THE DOOR IS CLEAR. b) The control station and placard are located within sight of the doorway. c) Automatic closing controls are not installed. d) Operator must remain at the control station and observe the door until the door is closed.
1910.147 C01
- Issued
- Mar 20, 2002
- Abate by
- May 6, 2002
1910.212 A05
- Issued
- Mar 20, 2002
- Abate by
- May 6, 2002
1910.219 E01 I
- Issued
- Mar 20, 2002
- Abate by
- May 6, 2002
More inspections at Atlantic County Fleet Maintenance Facility
View Atlantic County Fleet Maintenance Facility's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 304370836.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.