CONCORD, NH —
OSHA Inspection: MERIDIAN CONSTRUCTION CORPORATION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MERIDIAN CONSTRUCTION CORPORATION in STATE HOSPITAL COMPLEX - TOBEY BLDG., CONCORD, NH 03301 (NAICS 000000). OSHA activity number 304554751.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MERIDIAN CONSTRUCTION CORPORATION
- Site address
- STATE HOSPITAL COMPLEX - TOBEY BLDG.
- City
- CONCORD
- State
- NH
- ZIP
- 03301
- Mailing
- PO BOX 759, LACONIA, NH 03247
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1542
- Employees
- 5
- Ownership type
- A
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Jan 17, 2002
- Abate by
- Jan 24, 2002
- Penalty
- Initial $625 · Current $625
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of falling approximately three stories to the ground: a.Site - An employee was sitting on the top rail of the gate, with one leg on the outside of the platform and one leg inside the platform while working from a platform affixed to the forks of a Lull 844C-42 lift. He was not wearing fall protection. b.Site - An employee had used the railings of the platform to gain additional height. c.Site - The midrail on the basket was damaged (bent), and deflected about 4 inches downward. ABATEMENT NOTE: Among other methods, one feasible and acceptable means of abatement would be to comply with the requirements of the American National Standards Institute (ANSI) B56.6 - 1992 and (Addenda B56.6a - 1994) to ensure that employees maintain firm footing on the platform floor unless secured by a fall protection system. Also, the railing of the platform must be repaired or replaced.
More inspections at Meridian Construction Corporation
View Meridian Construction Corporation's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 304554751.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.