Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,124Inspections Most recent open 2026-08-25 Last loaded 2026-08-28

OSHA Inspection: A & J - 1 TRUCKING

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of A & J - 1 TRUCKING in 75 CROWS MILL RD., KEASBEY, NJ 08832 (NAICS 484220). OSHA activity number 304729023.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch A & J - 1 Trucking for free Get an email when a new federal OSHA severe-injury report for A & J - 1 Trucking is published. One employer, no account, unsubscribe in one click.
Establishment
A & J - 1 TRUCKING
Site address
75 CROWS MILL RD.
City
KEASBEY
State
NJ
ZIP
08832
Mailing
57 NEW LAWN AVE., KEARNY, NJ 07032
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (N)
Opened
Closing conference
Case closed
Data loaded
NAICS code
484220
SIC code (legacy)
4212
Employees
5
Ownership type
Private (A)
Industry flags
Manufacturing safety.

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 10 1 instance 1 exposed
Issued
Mar 10, 2003
Abate by
Mar 14, 2003
Penalty
Initial $1,500 · Current $750 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which was free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employee
was exposed to tipping and/or crushing hazards while operating a dump
truck:
a- Bayshore Recycling Corp., 75 Crows Mill Rd., Keasbey, NJ - On or about
10/7/02, an employee was operating a dump truck on a steep/narrow road
with the
hydraulics fully extended.  During this process the load shifted, causing
the truck to
tip over, trapping the employee inside.
REFERENCE:  National Safety Council Motor Trucks for Mines, Quarries and
Construction.  Data Sheet I-330-Rev.83; Section:  Operation of Vehicles,
paragraph
26, page 4.
Among other methods, one feasible and acceptable method to correct this
hazard is to:
1) Use trained ground personnel to guide truck drivers while backing up
their
vehicles on this road/hill.
2) Install perimeter markings, stakes or warning signs on the sides of
steep
roads/hills that are clearly visible to all truck drivers using the road.
Recent events (2)
  • · I (S) $750.00
  • · Z (S) $1500.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 304729023.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.