ROSWELL, NM —
OSHA Inspection: MOUNTAIN STATES ROOFING INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MOUNTAIN STATES ROOFING INC. in 2350 N MAIN, ROSWELL, NM 88201 (NAICS 000000). OSHA activity number 305233991.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MOUNTAIN STATES ROOFING INC.
- Site address
- 2350 N MAIN
- City
- ROSWELL
- State
- NM
- ZIP
- 88201
- Mailing
- 7233 POTOMAC DR, BOISE, ID 83704
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1761
- Employees
- 22
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
90005 A
- Issued
- May 20, 2002
- Abate by
- Jun 14, 2002
- Penalty
- Initial $100 · Current $100
General-duty citation text
Section 50-9-5(A), NMSA 1978 (New Mexico Occupational Health and Safety Act): Every employer shall furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees. At the Home Depot construction project in Roswell, the employee using the Gradall rough terrain forklift, Model #534D6-42, Serial # 0788009, was not using his seatbelt while operating the equipment along the southeast corner of the facility to place material on the roof although the forklift was equipped with a seatbelt and site rules required its use when operating. One feasible and acceptable abatement method includes but is not limited to the statement below. Not using a seatbelt while operating a forklift is contrary to ANSI B56.1d - 1992 5.3.19, which states: An active operator protection device or system, when provided, shall be used. Operator protection in the event of tipover is intended to reduce the risk of entrapment of the head and torso between the truck and the ground but may not protect the operator against all possible injury (see paragraph 7.2.2). However, steps indicated in paragraphs 5.3.18(d)-(e) should still be adhered to. Date Corrected: Describe Corrective Action:
1926.416 E01
- Issued
- May 20, 2002
- Abate by
- May 23, 2002
More inspections at Mountain States Roofing INC.
View Mountain States Roofing INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NM
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 305233991.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.