INDIANTOWN, FL —
OSHA Inspection: RODRIGUEZ CITRUS & VEGETABLES, INC.
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of RODRIGUEZ CITRUS & VEGETABLES, INC. in 16800 SW KANNER HWY., INDIANTOWN, FL 34956 (NAICS 000000). OSHA activity number 305495525.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RODRIGUEZ CITRUS & VEGETABLES, INC.
- Site address
- 16800 SW KANNER HWY.
- City
- INDIANTOWN
- State
- FL
- ZIP
- 34956
- Mailing
- 3015 CORKWOOD STREET, LAKE PARK, FL 33403
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 0722
- Employees
- 90
- Ownership type
- A
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Jul 16, 2002
- Abate by
- Jul 26, 2002
- Penalty
- Initial $4,900 · Current $4,900
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish to each of his employees employment and a place of employment which were free from recognized hazards that were causing or were likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of being struck-by a harvesting truck: On or about 05/02/02, at the center of block 28 of Division II, employees were exposed to the hazard of being struck and run over by powered equipment with lack of rear visibility operated in reverse gear. Among other methods of abatement, feasible and acceptable methods to correct this hazard are: (a) to install side and rear mirrors to enhance the visibility of the operator while backing up a loader truck; (b) to eliminate the practice of backing up the loader trucks in the drive middle; (c) to use a ground guide while the loader truck is backing up; and (d) to install rear view safety vision monitors that could eliminate blind spots at the rear of the loader truck. PLEASE NOTE: CERTIFICATION AND DOCUMENTATION OF ABATEMENT IS REQUIRED FOR THIS VIOLATION.
More inspections in this industry (NAICS 000000)
More inspections in FL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 305495525.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.