Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: GENCO SERVICES, INC.

Unprogrammed Related inspection · Safety discipline

On , OSHA opened an unprogrammed Related safety inspection of GENCO SERVICES, INC. in EAST SANTA FE RANCH A-2 TOM EAST FIELD BROOKS COUN, ENCINO, TX 78353 (NAICS 213112). OSHA activity number 305898835.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Genco Services, INC. for free Get an email when a new federal OSHA severe-injury report for Genco Services, INC. is published. One employer, no account, unsubscribe in one click.
Site address
EAST SANTA FE RANCH A-2 TOM EAST FIELD BROOKS COUN
City
ENCINO
State
TX
ZIP
78353
Mailing
1701 WEST HWY 107, MCALLEN, TX 78504
Inspection type
Unprogrammed Related (G)
Scope
Complete (A)
Discipline
Safety
Advance notice
Yes
Union status
Non-union (N)
Opened
Closing conference
Case closed
Data loaded
NAICS code
213112
SIC code (legacy)
1389
Employees
2
Ownership type
Private (A)

1 citation on file for this inspection.

5(a)(1)

Deleted Serious Gravity 10 1 instance 6 exposed
Issued
Apr 15, 2003
Abate by
Apr 21, 2003
Penalty
Initial $1,500
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to a struck-by hazard:
On or about October 28, 2003 at times prior and thereto, at the East Santa
Fe
Ranch A-2 well site, employees were exposed to the hazard of being struck
by
pressurized flow lines that had not been properly secured to the auger
anchors.
Among other methods, one feasible and acceptable abatement method to
correct
this hazard would be a properly spliced wire rope secured with the
appropriate
number of Crosby Clips installed according to the manufacturer's
recommendations. 0   0   y   0                                                 L
Recent events (2)
  • · I (S)
  • · Z (S) $1500.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 305898835.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.