SAN ANTONIO, TX —
OSHA Inspection: CORLEY BAILEY PLUMBING CO.
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of CORLEY BAILEY PLUMBING CO. in 203 HUMBLE, SAN ANTONIO, TX 78297 (NAICS 238990). OSHA activity number 306060674.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- CORLEY BAILEY PLUMBING CO.
- Site address
- 203 HUMBLE
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78297
- Mailing
- 2940 S. W.W. WHITE RD, SAN ANTONIO, TX 78297
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 238990
- SIC code (legacy)
- 1711
- Employees
- 2
- Ownership type
- A
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Jan 27, 2003
- Abate by
- Jan 31, 2003
- Penalty
- Initial $750 · Current $750
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: a) On or about 26 Dec 2002 two employees were working in a man basket being elevated by a forklift. The employees were replacing a 4 inch (101.6mm) vent pipe. The work area was at an elevation of approximately 15 feet (4.572m). The employees were exposed to a fall hazard due to the lack of a self locking access bar / door on the basket. The basket did not have a load rating and did not have a toe board for the door area. The forklift and basket was not in compliance with ANSI B56.1-1969 in that they were not inspected prior to use. b) The employees operating the man basket were exposed to a fall hazard due to the lack of training provided by the employer in operating this particular man basket. Among other methods, one feasible and acceptable abatement method to correct the hazards would be to obtain a man basket that is approved by the manufacturer of the forklift and use the basket with that specific forklift. Ensure that the basket has self latching access bar/ door that opens inward only. Ensure that the basket and forklift meet the requirements of ANSI B56.1-1969.s
More inspections in this industry (NAICS 238990)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 306060674.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.