SAN ANTONIO, TX —
OSHA Inspection: HANNASCH ELECTRIC INC.
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of HANNASCH ELECTRIC INC. in 4538 VANCE JACKSON, SAN ANTONIO, TX 78230 (NAICS 238210). OSHA activity number 306065921.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- HANNASCH ELECTRIC INC.
- Site address
- 4538 VANCE JACKSON
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78230
- Mailing
- 24 COMMERCIAL PLACE, SHERTZ, TX 78154
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238210
- SIC code (legacy)
- 1731
- Employees
- 6
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 18, 2004
- Abate by
- Feb 24, 2004
- Penalty
- Initial $2,800 · Current $2,000 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of electrical shock: a) The employer did not ensure employees were not wearing conductive articles such as, but not limited too, wrist watch, wrist band, necklaces, and rings when working around 277 volt energized equipment. Employer did not train employees on the hazards associated with wearing conductive articles. Among other feasible and useful abatement methods, one method to abate this hazard would be to follow NFPA 70E Part 2, chapter (2) 2-3.5 conductive article shall not be worn such as, watches, necklaces, rings etc. b) The employer did not explain the potential hazards involved in the job and/or procedures to follow to minimize the potential hazard such as, but not limited too, energy isolation sources and controls, personal protective equipment to be used, such as, but not limited to, clothing, tools applicable to electricity etc. Among other feasible and useful abatement methods, one method to abate this hazard would be to follow the guidance on NFPA 70E Part 2, Chapter(2) 2-3.1.6, The employee in charge shall conduct a job briefing with the employees involved. The briefing shall cover such subjects as hazards associated with the job, work procedures involved, special precautions, energy source controls, and personal protective equipment requirements.
Recent events (2)
- — I (S) $2000.00
- — Z (S) $2800.00
1926.50 B
- Issued
- Feb 18, 2004
- Abate by
- Feb 24, 2004
- Penalty
- Initial $2,000
Recent events (2)
- — I (S)
- — Z (S) $2000.00
1926.416 A01
- Issued
- Feb 18, 2004
- Abate by
- Feb 24, 2004
- Penalty
- Initial $2,800 · Current $2,000 Reduced
Recent events (2)
- — I (S) $2000.00
- — Z (S) $2800.00
1926.416 A03
- Issued
- Feb 18, 2004
- Abate by
- Feb 24, 2004
Recent events (2)
- — I (S)
- — Z (S)
More inspections at Hannasch Electric INC.
View Hannasch Electric INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238210)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 306065921.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.