SAN ANTONIO, TX —
OSHA Inspection: MOORE ERECTION LP
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of MOORE ERECTION LP in 15355 LAMBADA DRIVE, SAN ANTONIO, TX 78266 (NAICS 238120). OSHA activity number 306068677.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MOORE ERECTION LP
- Site address
- 15355 LAMBADA DRIVE
- City
- SAN ANTONIO
- State
- TX
- ZIP
- 78266
- Mailing
- 19219 FM 2252, GARDEN RIDGE, TX 78266
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238120
- SIC code (legacy)
- 1791
- Employees
- 60
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- May 5, 2004
- Abate by
- May 10, 2004
- Penalty
- Initial $4,200 · Current $4,200
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of falls in that: a) The employer did not ensure that the Genie S-65 Boom lift was operated in accordance with the American National Standard Institute 92.5 standard (ANSI) 92.5) which states in Section 7.9 that "The aerial platform shall be used in accordance with this standard. The user shall ensure that before each movement of the aerial platform, if repositioning the platform, that the operator shall ensure the aerial platform is operated on a surface within the limits specified by the manufacturer. The manufacturer's operating instructions state; do not raise or extend the boom unless the machine is on a firm level surface. On or about April 7, 2004, the employer allowed the Genie S-65 Boom lift to be operated while on a slope surface at the Northwest corner of the building which resulted in the fatal accident when the boom lift tipped over. This condition was exacerbated by the wet ground conditions from recent rain. Among other methods, recognized and feasible means to correct this hazard include, but are not limited to prohibiting the use of the Genie S-65 Boom lift on a sloped or unlevel surface.
Recent events (2)
- — F (S) $4200.00
- — Z (S) $4200.00
1926.20 B02
- Issued
- May 5, 2004
- Abate by
- May 10, 2004
- Penalty
- Initial $4,200 · Current $4,200
Recent events (2)
- — F (S) $4200.00
- — Z (S) $4200.00
1926.351 B02
- Issued
- May 5, 2004
- Abate by
- May 11, 2004
- Penalty
- Initial $1,500 · Current $1,500
Recent events (2)
- — F (S) $1500.00
- — Z (S) $1500.00
1926.453 B02 I
- Issued
- May 5, 2004
- Abate by
- May 12, 2004
- Penalty
- Initial $900 · Current $900
Recent events (2)
- — F (S) $900.00
- — Z (S) $900.00
More inspections at Moore Erection LP
View Moore Erection LP's full OSHA safety record →
More inspections in this industry (NAICS 238120)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 306068677.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.