NEW YORK, NY —
OSHA Inspection: GEORGE KAJDACSI, INC.
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of GEORGE KAJDACSI, INC. in 93 FRANKLIN STREET, NEW YORK, NY 10013 (NAICS 238220). OSHA activity number 306840166.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- GEORGE KAJDACSI, INC.
- Site address
- 93 FRANKLIN STREET
- City
- NEW YORK
- State
- NY
- ZIP
- 10013
- Mailing
- 466 WASHINGTON STREET, NEW YORK, NY 10013
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 238220
- SIC code (legacy)
- 1711
- Employees
- 6
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Aug 19, 2003
- Abate by
- Aug 27, 2003
- Penalty
- Initial $750 · Current $750
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to being caught by rotating machine parts: a)Floor 3: Employees who were performing pipe threading were exposed to contacting and being caught by the rotating parts of a cord and plug connected Ridgid Model 300 Pipe and Bolt Threading Machine. Employees caught by these pards may be unable to reach the control switch in order to stop the machine before serious injury or death occurs. On or about 08/06/03 ABATEMENT NOTE: Among others, a feasible method to eliminate or to materially reduce this hazard is to comply with American National Standards Institute B208.1 - 1982, section 4.4 and install a momentary contact device to control the power input to the machine. NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT CERTIFICATION OF ABATEMENT FOR THIS ITEM. FAILURE TO COMPLY MAY RESULT IN AN ADDITIONAL PENALTY OF $1,000 AS PER 29 CFR 1903.19.
1926.20 B02
- Issued
- Aug 19, 2003
- Abate by
- Aug 27, 2003
1926.21 B02
- Issued
- Aug 19, 2003
- Abate by
- Aug 27, 2003
More inspections at George Kajdacsi, INC.
View George Kajdacsi, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 238220)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 306840166.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.