ASHEVILLE, NC — 2003-08-07 00:00:00

OSHA Inspection: T-PRECISION MACHINING, INC.

Planned inspection · Safety discipline

At a glance

On 2003-08-07 00:00:00, OSHA opened a planned safety inspection of T-PRECISION MACHINING, INC. in 123 LYMAN STREET, ASHEVILLE, NC 28801 (NAICS 335312). OSHA activity number 306918350.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch T-Precision Machining, INC. — free Get an email when a new federal OSHA severe-injury report for T-Precision Machining, INC. is published. One employer, no account, unsubscribe in one click.

Where did this inspection happen?

Establishment: T-PRECISION MACHINING, INC.
Site address: 123 LYMAN STREET
City: ASHEVILLE
State: NC
ZIP: 28801

What kind of inspection was it?

Inspection type: Planned (H)
Scope: Complete (A)
Discipline: Safety
Advance notice: No
Union status: N

When did the case open and close?

Opened: 2003-08-07 00:00:00
Closing conference: 2003-08-07 00:00:00
Case closed: 2003-09-08 00:00:00
Data loaded: 2011-10-14 16:38:47

Establishment context

NAICS code: 335312
SIC code (legacy): 3621
Employees: 18
Ownership type: A
Industry flags: Manufacturing safety.

Citations

10 citations on file for this inspection.

95012901

Serious 1 instance 1 exposed

Issued: Aug 15, 2003
Abate by: Sep 11, 2003
Penalty: Initial $100 · Current $100

General-duty citation text

North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North
Carolina:  The employer did not furnish to each of his employees
conditions of employment
which were free from recognized hazards that were causing or likely to
cause death or serious
physical harm to employees:
Ref:ANSI B30.11-2.2.2(a)Rated Load Test
Note:Among other methods, one feasible and acceptable abatement method to
correct this hazard is
to have the monorail load tested.
(a)Paint Prep area -- Monorail used by employees had not been load
tested.es

95012901

Serious 1 instance 1 exposed

Issued: Aug 15, 2003
Abate by: Sep 11, 2003
Penalty: Initial $100 · Current $100

General-duty citation text

North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North
Carolina:  The employer did not furnish to each of his employees
conditions of employment
which were free from recognized hazards that were causing or likely to
cause death or serious
physical harm to employees:
Ref:  ANSI B30.20-1.4.2 - Rated Load Test
Note:Among other methods, one feasible and acceptable abatement method to
correct this hazard is
to have the spreader bar load tested.
(a)Paint shop -- Below the hook spreader bar had not been load tested.r

1910.178 L

Serious 1 instance 1 exposed

Issued: Aug 15, 2003
Abate by: Sep 11, 2003
Penalty: Initial $100 · Current $100

1910.178 Q07

Serious 1 instance 1 exposed

Issued: Aug 15, 2003
Abate by: Sep 4, 2003