BRUNSWICK, GA —
OSHA Inspection: MILLER TREE SERVICE
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of MILLER TREE SERVICE in 465 CARTERET ROAD, BRUNSWICK, GA 31525 (NAICS 561730). OSHA activity number 307414284.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MILLER TREE SERVICE
- Site address
- 465 CARTERET ROAD
- City
- BRUNSWICK
- State
- GA
- ZIP
- 31525
- Mailing
- 201 GRANTS FERRY ROAD, BRUNSWICK, GA 31525
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 561730
- SIC code (legacy)
- 0783
- Employees
- 5
- Ownership type
- A
Citations
9 citations on file for this inspection.
5(a)(1)
- Issued
- May 14, 2007
- Abate by
- May 17, 2007
- Penalty
- Initial $1,500
General-duty citation text
P.L. 91-596 Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard(s) of: a) Work site, 465 Carteret Rd. - The employer did not ensure that employees exposed to being struck by motor vehicles were wearing appropriate high-visibility apparel. b) Work site, 465 Carteret Rd. - The employer did not ensure that employees exposed to being struck by motor vehicles were protected by appropriate traffic cones and/or barricades. Among others, feasible and accepted methods to correct the hazard would be to follow the requirements outlined in the ANZI Z133.1, American National Standard for Aboricultural Operations - Safety Requirements: a) Assure that highway work zones are in accordance with Chapter 3, General Safety Requirements, Section 3.2, Traffic Control Around the Jobsite, paragraph 3.2.1: High-visibility safety apparel and headgear, when required, shall conform to ANSI-ISEA 107-2004 and the U.S. Department of Transportation (DOT) Manual on Uniform Traffic Control Devices (MUTCD). b) Assure that highway work zones are in accordance with Chapter 3, General Safety Requirements, Section 3.2, Traffic Control Around the Jobsite, paragraph 3.3.3: Temporary traffic-control devices used in aboricultural operations shall conform to the U.S. Department of Transportation (DOT) Manual on Uniform Traffic Control Devices (MUTCD) and applicable federal and state regulations.
Recent events (2)
- — A (S)
- — Z (S) $1500.00
1910.23 C01
- Issued
- May 14, 2007
- Abate by
- May 17, 2007
- Penalty
- Initial $750 · Current $700 Reduced
Recent events (2)
- — I (S) $700.00
- — Z (S) $750.00
5(a)(1)
- Issued
- May 14, 2007
- Abate by
- May 17, 2007
General-duty citation text
P.L. 91-596 Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to fall hazards: a) Work site, East elevation - Employees using a portable metal extension ladder to access/egress a roof were exposed to fall hazards from approximately 9 feet in that the ladder was not tied to the upper access level. Among others, one feasible and accepted method to correct the hazard would be follow the requirements outlined in the ANSI A14.2-2000 standard, American National Standard for Ladders - Portable Metal - Safety Requirements; Section 8: Selection, Care, and Use, paragraph 8.3.10 Getting On or Off Ladder at Upper Levels, which includes securing the ladder at the upper landing level and extending the ladder 3 feet at the upper landing level.g
1910.132 F01
- Issued
- May 14, 2007
- Abate by
- Jun 22, 2007
- Penalty
- Initial $750 · Current $650 Reduced
Recent events (2)
- — I (S) $650.00
- — Z (S) $750.00
1910.133 A01
- Issued
- May 14, 2007
- Abate by
- May 17, 2007
- Penalty
- Initial $750
Recent events (2)
- — I (S)
- — Z (S) $750.00
1910.135 A01
- Issued
- May 14, 2007
- Abate by
- May 17, 2007
- Penalty
- Initial $750 · Current $650 Reduced
Recent events (2)
- — I (S) $650.00
- — Z (S) $750.00
1910.1200 E01
- Issued
- May 14, 2007
- Abate by
- Jun 22, 2007
1910.1200 G01
- Issued
- May 14, 2007
- Abate by
- Jun 22, 2007
1910.1200 H01
- Issued
- May 14, 2007
- Abate by
- Jun 22, 2007
More inspections in this industry (NAICS 561730)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 307414284.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.