HORNELL, NY ·
OSHA Inspection: ALSTOM TRANSPORTATION, INC.
Planned inspection · Health discipline
At a glance
On , OSHA opened a planned health inspection of ALSTOM TRANSPORTATION, INC. in 1 ALSTOM DRIVE, HORNELL, NY 14843 (NAICS 336510). OSHA activity number 307690933.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ALSTOM TRANSPORTATION, INC.
- Site address
- 1 ALSTOM DRIVE
- City
- HORNELL
- State
- NY
- ZIP
- 14843
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Health
- Advance notice
- No
- Union status
- Union (Y)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 336510
- SIC code (legacy)
- 3743
- Employees
- 600
- Ownership type
- Private (A)
- Industry flags
- Manufacturing health.
Citations
6 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 14, 2005
- Abate by
- Nov 1, 2005
- Penalty
- Initial $2,250 · Current $1,913 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of amputation from high pressure water operating at 38,000 pounds per square inch (PSI): a. On or about 07/28/2005, in the strip and wash shop: Employees operate high pressure Pratt& Whitney/NLB waterjetting equipment at a working pressure of 38,000 PSI. The Waterjetting equipment was defective in that the safety trigger switch was not operational leading to the hazard of amputation if the gun was dropped because the switch would not disengage and the 38,000 PSI stream could hit the operator. b. On or about 07/28/2005, in the strip and wash shop: Employees were not trained to inspect the equipment for defects. Among others some feasible abatement methods are to follow the safety procedures in the manufacture's operations manual, including but not limited to the following: 1.(Sec. 5.5) Require the daily inspection of the equipment and replacement of worn or defective equipment. 1.(Sec. 10.2) Provide operator training about high pressure waterjetting equipment. Abatement certification must be submitted for this Item.
Recent events (2)
- · J (S) $1912.50
- · Z (S) $2250.00
1910.106 E02 IIB2
- Issued
- Oct 14, 2005
- Abate by
- Nov 1, 2005
- Penalty
- Initial $1,800 · Current $1,530 Reduced
Recent events (2)
- · J (S) $1530.00
- · Z (S) $1800.00
1910.151 C
- Issued
- Oct 14, 2005
- Abate by
- Oct 19, 2005
- Penalty
- Initial $1,800 · Current $1,530 Reduced
Recent events (2)
- · J (S) $1530.00
- · Z (S) $1800.00
1910.1027 D01 I
- Issued
- Oct 14, 2005
- Abate by
- Oct 19, 2005
- Penalty
- Initial $1,350 · Current $1,148 Reduced
Recent events (2)
- · J (S) $1147.50
- · Z (S) $1350.00
1910.1027 L01 IA
- Issued
- Oct 14, 2005
- Abate by
- Nov 1, 2005
Recent events (2)
- · J (S)
- · Z (S)
1910.1027 M04 I
- Issued
- Oct 14, 2005
- Abate by
- Nov 1, 2005
Recent events (2)
- · J (S)
- · Z (S)
More inspections at Alstom Transportation, INC.
View Alstom Transportation, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 336510)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 307690933.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.