LAYTON, NJ ·
OSHA Inspection: AYERS CORPORATION
Programmed Related inspection · Safety discipline
At a glance
On , OSHA opened a programmed Related safety inspection of AYERS CORPORATION in 76 ROUTE 560, LAYTON, NJ 07851 (NAICS 562111). OSHA activity number 307999557.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AYERS CORPORATION
- Site address
- 76 ROUTE 560
- City
- LAYTON
- State
- NJ
- ZIP
- 07851
What kind of inspection was it?
- Inspection type
- Programmed Related (I)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 562111
- SIC code (legacy)
- 4212
- Employees
- 14
- Ownership type
- Private (A)
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Dec 8, 2004
- Abate by
- Dec 20, 2004
- Penalty
- Initial $1,500 · Current $1,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to falling/struck-by hazards: a) Employees were exposed to the hazard of falling off of a deformed rider step on truck #1. b) The container locking devices ( trunnion pivot plates) were inoperable on truck # 5, a rear load truck, creating a hazard of an employee being struck by a container as it is lifted for tipping. Feasible and acceptable methods of abatement include but are not limited to: 1) Repairing the rear rider step on truck #1 to provide a level surface for employees to stand on. 2) Repairing the pivot plate on truck #5 to provide a safe method of raising containers. 3) Implement a pre- trip inspection procedure of trucks as detailed in the Manual of Recommended Safety Practices, Part IV : Mobile Collection & Transportation Operations, issued by the Environmental Industry Associations & the Waste Equipment Technology Association, June 1999. Violation observed on or about 11/19/2004.,
More inspections at Ayers Corporation
View Ayers Corporation's full OSHA safety record →
More inspections in this industry (NAICS 562111)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 307999557.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.