Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,191,871Inspections Most recent open 2026-07-30 Last loaded 2026-08-03

OSHA Inspection: FREDERICO, INC.

Unprogrammed Related inspection · Safety discipline

On , OSHA opened an unprogrammed Related safety inspection of FREDERICO, INC. in 600 NW 4TH AVE., BOCA RATON, FL 33432 (NAICS 238910). OSHA activity number 308404995.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Frederico, INC. for free Get an email when a new federal OSHA severe-injury report for Frederico, INC. is published. One employer, no account, unsubscribe in one click.
Establishment
FREDERICO, INC.
Site address
600 NW 4TH AVE.
City
BOCA RATON
State
FL
ZIP
33432
Mailing
231 NW 18TH AVE., DELRAY BEACH, FL 33444
Inspection type
Unprogrammed Related (G)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238910
SIC code (legacy)
1795
Employees
4
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 03 1 instance 1 exposed
Issued
Jun 20, 2005
Abate by
Jun 23, 2005
Penalty
Initial $375 · Current $375
Section 5(a)1 of the Occupational Safety and Health Act of 1970:
The employer did not furnish to each of his employees employment and a
place of employment
which were free from recognized hazards that were causing or likely to
cause death or serious
physical harm to employees in that employees were exposed to:
On or about 4/25/05, an employee was exposed to struck-by and crushing
hazards because he
was operating a Skid Loader while the forward view was obstructed by an
elevated bucket.
Among other methods of abatement, a feasible and acceptable method to
correct these hazards
is to follow the operator's manual of the equipment which indicates that
for maximum stability
carry load as low as possible.
PLEASE NOTE:  CERTIFICATION OF ABATEMENT IS NOT REQUIRED FOR THIS
VIOLATION.

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 308404995.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.