MAYPORT, FL —
OSHA Inspection: WALT'S WRECKER SERVICE, LLC
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of WALT'S WRECKER SERVICE, LLC in ECHO # 2 PIER, MAYPORT NAVAL STATION, MAYPORT, FL 32228 (NAICS 488410). OSHA activity number 308435908.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- WALT'S WRECKER SERVICE, LLC
- Site address
- ECHO # 2 PIER, MAYPORT NAVAL STATION
- City
- MAYPORT
- State
- FL
- ZIP
- 32228
- Mailing
- 503 N. ELLIS RD., JACKSONVILLE, FL 32254
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- Yes
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 488410
- SIC code (legacy)
- 7549
- Employees
- 2
- Ownership type
- A
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Jun 8, 2006
- Abate by
- Jun 13, 2006
- Penalty
- Initial $4,900 · Current $3,500 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to being struck by material handling equipment and/or the load: a.On or about January 17, 2006, the 5/8-inch diameter wire rope that was used to pull the roll-off vacuum container onto the tow truck flatbed had separation among strands and crushed areas, exposing employees to the hazard of being struck by the load and the wire rope. ABATEMENT CERTIFICATION IS NOT REQUIRED. b.On or about January 17, 2006, the tie-down chain assembly that was used to pull a 10,100-pound roll-off vacuum container onto a tow truck flatbed was overloaded in that its working load limit was 2,650 pounds, exposing an employee to the hazard of being struck by the load and the tie-down assembly. ABATEMENT CERTIFICATION IS NOT REQUIRED. c.On or about January 17, 2006, the swivel hook that was used to pull a 10,100- pound roll-off vacuum container onto a tow truck flatbed was overloaded in that its working load limit was 10,000 pounds, exposing employees to the hazard of being stuck by the load and swivel hook. ABATEMENT CERTIFICATION IS REQUIRED. Among other methods, a feasible means of abatement would be to: 1. purchase, install, use, and properly maintain rigging equipment such as chains, slings, wire ropes, and hooks that have sufficient working load ratings to safely lift or pull the intended loads, and to train employees how to safely install, use and maintain the equipment.
Recent events (2)
- — F (S) $3500.00
- — Z (S) $4900.00
1904.39 A
- Issued
- Jun 8, 2006
- Abate by
- Jun 13, 2006
- Penalty
- Initial $2,500 · Current $1,500 Reduced
Recent events (2)
- — F (O) $1500.00
- — Z (O) $2500.00
More inspections in this industry (NAICS 488410)
More inspections in FL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 308435908.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.