HOUSTON, TX ·
OSHA Inspection: OMEGA NATCHIQ, INC.
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of OMEGA NATCHIQ, INC. in 9600 CLINTON DR., HOUSTON, TX 77547 (NAICS 333132). OSHA activity number 308587112.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- OMEGA NATCHIQ, INC.
- Site address
- 9600 CLINTON DR.
- City
- HOUSTON
- State
- TX
- ZIP
- 77547
- Mailing
- 15115 PARK ROW STE 165, HOUSTON, TX 77084
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 333132
- SIC code (legacy)
- 3533
- Employees
- 10
- Ownership type
- Private (A)
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Nov 18, 2005
- Abate by
- Dec 21, 2005
- Penalty
- Initial $6,300 · Current $3,000 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the following conditions: a)On or about 06/21/05, employees and subcontractor employees were exposed to a struck-by and caught-between hazard because the crane operator was not retrained following two near miss incidents, and on 06/21/05, overturned a Grove RT990 mobile hydraulic crane while traveling with a wire line deck weighing approximately 11,647 pounds at the National Oilwell Varco South Yard. While performing this pick and carry operation, the operator did not insure that the mechanical swing lock was locked, did not maintain the boom within the defined arc of six degrees on either side of the longitudinal centerline of the machine, did not ensure tires were inflated to recommended pressure prior to lifting on rubber, did not make due allowance for uneven ground conditions as described in the load charts for the crane. Among others, one feasible and acceptable method to abate the condition would be to insure that designated crane operators are qualified by requiring them to pass a practical examination, limited to the specific type equipment to be operated, as described in USA Standard B30.5-1968, Section 5- 3.1.2, and to retrain operators involved in near miss incidents when investigation indicates retraining could prevent further incidents. *** Certification and Documentation of Abatement Required ***
Recent events (2)
- · F (S) $3000.00
- · Z (S) $6300.00
1910.180 H01 I
- Issued
- Nov 18, 2005
- Abate by
- Nov 23, 2005
- Penalty
- Initial $6,300 · Current $6,300
Recent events (2)
- · F (S) $6300.00
- · Z (S) $6300.00
1910.180 H03 IX
- Issued
- Nov 18, 2005
- Abate by
- Nov 23, 2005
Recent events (2)
- · F (S)
- · Z (S)
1910.180 H03 XIV
- Issued
- Nov 18, 2005
- Abate by
- Dec 21, 2005
- Penalty
- Initial $6,300 · Current $3,000 Reduced
Recent events (2)
- · F (S) $3000.00
- · Z (S) $6300.00
More inspections at Omega Natchiq, INC.
View Omega Natchiq, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 333132)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 308587112.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.