Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: HENREDON FURNITURE INDUSTRIES, INC. DBA HDM

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of HENREDON FURNITURE INDUSTRIES, INC. DBA HDM in 400 HENREDON RD, MORGANTON, NC 28655 (NAICS 337122). OSHA activity number 308742162.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Henredon Furniture Industries, INC. DBA HDM — free Get an email when a new federal OSHA severe-injury report for Henredon Furniture Industries, INC. DBA HDM is published. One employer, no account, unsubscribe in one click.
Site address
400 HENREDON RD
City
MORGANTON
State
NC
ZIP
28655
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
337122
SIC code (legacy)
2511
Employees
500
Ownership type
A
Industry flags
Manufacturing safety.

19 citations on file for this inspection.

95012901

Serious 19 instances 200 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006
Penalty
Initial $1,375 · Current $481 Reduced
North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North Carolina:  The
employer did not furnish to each of his employees conditions of employment
and a place of employment which
were free from recognized hazards that were causing or likely to cause
death of serious physical harm to
employees:
a)Site -- Facility-Wide:  The employer did not perform a rated load test
of the nineteen bottom-running cranes and hoists installed within the
facility.
REFERENCE:ANSI/ASME B30.11 - Monorails and Underhung Cranes:
Chapter 11-2 - Inspection, Testing, and Maintenance:
Section 11-2.2.2 - Load Test:
a)New, reinstalled, altered, repaired, and modified equipment should be
load tested prior to initial use as determined by a qualified person.
NOTE:Among other methods, one feasible and acceptable abatement method to
correct this
hazard is to have a rated load test performed by a competent person for
each crane or
hoist installed within the facility and to maintain the documentation of
these
load tests on
site in a permanent file.
Recent events (2)
  • — I (S) $481.25
  • — Z (S) $1375.00

95012901

Deleted Serious 19 instances 100 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006
Penalty
Initial $1,375
North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North Carolina:  The
employer did not furnish to each of his employees conditions of employment
and a place of employment which
were free from recognized hazards that were causing or likely to cause
death of serious physical harm to
employees:
a) Site -- Facility-Wide:  The employer did not establish an effective
inspection program to ensure
frequent and period inspection by a competent person of the nineteen
underhung cranes and hoists
installed within the facility.
REFERENCE:ANSI/ASME B30.16 - Overhead Hoist (Underhung):
Chapter 16-2 - Inspection, Testing, and Maintenance:
Section 16-2.1.1 - Inspection Classification:
b)1)Frequent Inspection:  Visual examinations by the operator of
other designated person with records not required:
a)Normal Service:  monthly.
b)Heavy Service:  weekly to monthly.
c)Severe Service:  daily to weekly.
2)Periodic Inspection:  Visual inspection by a designated person
who makes records of external conditions to provide the basis
for a continuing evaluation.
a)Normal Service:  yearly.
b)Heavy Service:  semi-annually.
c)Severe Service:  quarterly.
NOTE:Among other methods, one feasible and acceptable method to correct
this hazard is to
develop and  implement an inspection procedure for the cranes and hoists
installed
within the facility that ensures the required inspections covering the
items listed in
B30.16 - Chapter 2 are performed by competent personnel in compliance with
the
schedules contained in the Chapter.
Recent events (2)
  • — I (S)
  • — Z (S) $1375.00

95012901

Serious 19 instances 100 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006
Penalty
Initial $1,375 · Current $481 Reduced
North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North Carolina:  The
employer did not furnish to each of his employees conditions of employment
and a place of employment which
were free from recognized hazards that were causing or likely to cause
death or serious physical harm to
employees:
a)  Site -- Facility-Wide:  The rated load capacity for the nineteen
underhung cranes installed within the
facility was not marked such that the load capacity was clearly legible
from the floor.
REFERENCE:ANSI  B30.16 - Overhead Hoists (Underhung):
Chapter 16-1 - Marking, Construction, and Installation:
Section 1.1.1 - Rated Load.  The rated load of the hoist shall be marked
on the
hoist of its load block and shall be legible from the ground or the floor.
NOTE:Among other methods, one feasible and acceptable method to correct
this
hazard is to
clearly mark the rated load capacity of the hoists on the hoist, the load
block, or the
support rails so that the load capacity for each hoist is clearly legible
from the floor.e
Recent events (2)
  • — I (S) $481.25
  • — Z (S) $1375.00

1910.212 A05

Serious 1 instance 15 exposed
Issued
Jan 13, 2006
Abate by
Jan 19, 2006
Penalty
Initial $963 · Current $337 Reduced
Recent events (2)
  • — I (S) $337.00
  • — Z (S) $963.00

1910.304 F04

Serious 2 instances 50 exposed
Issued
Jan 13, 2006
Abate by
Jan 19, 2006
Penalty
Initial $963 · Current $337 Reduced
Recent events (2)
  • — I (S) $337.00
  • — Z (S) $963.00

1910.304 F05 VC5

Serious 1 instance 300 exposed
Issued
Jan 13, 2006
Abate by
Jan 19, 2006
Penalty
Initial $1,375 · Current $550 Reduced
Recent events (2)
  • — I (S) $550.00
  • — Z (S) $1375.00

1910.305 G02 III

Serious 8 instances
Issued
Jan 13, 2006
Abate by
Feb 9, 2006
Penalty
Initial $825 · Current $314 Reduced
Recent events (2)
  • — I (S) $313.50
  • — Z (S) $825.00

1910.22 D01

Other-than-serious 2 instances 20 exposed
Issued
Jan 13, 2006
Abate by
Feb 9, 2006

1910.23 D01 IV

Other-than-serious 2 instances 50 exposed
Issued
Jan 13, 2006
Abate by
Feb 9, 2006

1910.110 F02 I

Other-than-serious 1 instance 50 exposed
Issued
Jan 13, 2006
Abate by
Jan 19, 2006

1910.179 H04

Other-than-serious 1 instance 25 exposed
Issued
Jan 13, 2006
Abate by
Jan 19, 2006

1910.212 A01

Other-than-serious 3 instances 10 exposed
Issued
Jan 13, 2006
Abate by
Mar 3, 2006

1910.219 C04 I

Other-than-serious 1 instance 5 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006

1910.303 B01

Other-than-serious 4 instances 100 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006

1910.303 B02

Other-than-serious 3 instances 30 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006

1910.303 F

Other-than-serious 3 instances 50 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006

1910.305 B01

Other-than-serious 1 instance 60 exposed
Issued
Jan 13, 2006
Abate by
Jan 26, 2006

1910.305 G01 IIIA

Other-than-serious 3 instances 20 exposed
Issued
Jan 13, 2006
Abate by
Feb 9, 2006

1910.1200 F05 I

Other-than-serious 2 instances 10 exposed
Issued
Jan 13, 2006
Abate by
Jan 19, 2006

View Henredon Furniture Industries, INC. DBA HDM's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 308742162.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.