MARLTON, NJ —
OSHA Inspection: OCCUPATIONAL TRAINING CENTER OF BURLINGTON COUNTY
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of OCCUPATIONAL TRAINING CENTER OF BURLINGTON COUNTY in CARLTON AVE. & WESSIX PLACE, MARLTON, NJ 08053 (NAICS 423930). OSHA activity number 309250264.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- OCCUPATIONAL TRAINING CENTER OF BURLINGTON COUNTY
- Site address
- CARLTON AVE. & WESSIX PLACE
- City
- MARLTON
- State
- NJ
- ZIP
- 08053
- Mailing
- 130 HANCOCK LANE, MT. HOLLY, NJ 08060
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 423930
- SIC code (legacy)
- 5093
- Employees
- 756
- Ownership type
- A
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Dec 6, 2005
- Abate by
- Dec 9, 2005
- Penalty
- Initial $4,500 · Current $3,000 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees where exposed to fall hazards from a moving vehicle: On or about 09/02/05: a) Roadway, Carlton Ave. and Wessix Place, Marlton N.J. - Employees (laborers) permitted to ride on unintended riding areas such as but not limited to, the exterior of the cab on the drivers-side of a moving Crane Carrier Co. Model LET2 refuse/recycling truck, were exposed to fall hazards. Among others, reasonable and useful methods to abate the hazard would be to develop and implement a policy that follows the requirements outlined in the American National Standard Institute's standard for "Mobile Wastes and Recyclable Materials Collection, Transportation, and Compaction Equipment - Safety Requirements" (ANSI Z245-1-1999) and in the Crane Carrier Co. Operation Manual. These requirements include but are not limited to: a) "Riding only in the cab, except where riding steps are provided, and not riding anywhere else on the vehicle." b) "Do not stand on the steps or any other part of the vehicle while it is in motion. The steps are for entering/exiting the vehicle and not for riding on. Failure to heed this warning may result in serious personal injury or death". NOTE: IN ADDITION TO ABATEMENT CERTIFICATION, THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT DOCUMENTATION FOR THIS ITEM, FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.
Recent events (2)
- — I (S) $3000.00
- — Z (S) $4500.00
More inspections at Occupational Training Center of Burlington County
View Occupational Training Center of Burlington County's full OSHA safety record →
More inspections in this industry (NAICS 423930)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 309250264.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.