OSHA Inspection: O'NEAL'S WELDING & FABRICATION

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Penalty

Initial $225

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to struck by hazards:
In the following locations, pressure vessels used in support of radial arm
drill
rainwater coolant fluid distribution operations were not stamped and
reported
exposing employees to struck by hazards:
a.Machine Shop, West Wall, North End: Pressure vessel used to provide
rainwater coolant fluid under pressure to hollow area of radial arm drill
bit device,
b.Machine Shop, South Wall, East End: Pressure vessel used to provide
rainwater coolant fluid under pressure to hollow area of radial arm drill
bit device,
c.Machine Shop, East Side, Center Wall Area: Pressure vessel used to
provide rainwater coolant fluid under pressure to hollow area of radial
arm drill bit device,
d.Weld Shop, West Wall, South End: Pressure vessel used to provide
rainwater coolant fluid under pressure to hollow area of radial arm drill
bit device.
In the following locations, pressure vessels used in support of radial arm
drill
rainwater coolant fluid distribution operations were not equipped with
pressure
relief valve exposing employees to struck by hazards:
e.Machine Shop, West Wall, North End: Pressure vessel used to provide
rainwater coolant fluid under pressure to hollow area of radial arm drill
bit device,
f.Machine Shop, South Wall, East End: Pressure vessel used to provide
rainwater coolant fluid under pressure to hollow area of radial arm drill
bit device,
g.Machine Shop, East Side, Center Wall Area: Pressure vessel used to
provide rainwater coolant fluid under pressure to hollow area of radial
arm drill bit device,
h.Weld Shop, West Wall, South End: Pressure vessel used to provide
rainwater coolant fluid under pressure to hollow area of radial arm drill
bit device.
Among other methods, one feasible and acceptable abatement method to
correct these hazards
are the ASME stamp or mark and the installation of a pressure relief valve
for each pressure
vessel.

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Penalty

Initial $225 · Current $135 Reduced

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Penalty

Initial $225 · Current $135 Reduced

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Penalty

Initial $225 · Current $135 Reduced

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Penalty

Initial $225 · Current $135 Reduced

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Issued

Oct 19, 2005

Abate by

Oct 25, 2005

Issued

Oct 19, 2005

Abate by

Oct 24, 2005

Issued

Oct 19, 2005

Abate by

Oct 31, 2005

Issued

Oct 19, 2005

Abate by

Oct 31, 2005

Issued

Oct 19, 2005

Abate by

Oct 31, 2005