OSHA Inspection: CENTURY METAL SPINNING CO., INC.

Issued

Sep 26, 2005

Abate by

Oct 14, 2005

Penalty

Initial $750 · Current $450 Reduced

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to:
(a) Tool Room - The Delta vertical band saw used for cutting metal and
cardboard was not
equipped with a magnetic restarter or equivalent device.
Among other methods, one feasible and acceptable method to correct this
hazard is to
include, but not limited to the following:
(1) provide a magnetic restarter or similar device as required by the
American National Standard
for Metal Cutting Saws, ANSI B11.10-2003, Section 6.11.
In accordance with 29 CFR 1903.19(d), abatement certification is required
for this violation
(using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET), and in
addition, documentation demonstrating that abatement is complete must be
included with
your certification.  This documentation may include, but is not limited
to, evidence of the
purchase or repair of the equipment, photographic or video evidence of
abatement, or other
written records.

Issued

Sep 26, 2005

Abate by

Nov 14, 2005

Penalty

Initial $750 · Current $450 Reduced

Issued

Sep 26, 2005

Abate by

Oct 14, 2005

Penalty

Initial $600 · Current $300 Reduced