OSHA Inspection: DARMAN MANUFACTURING CO., INC.

Issued

Dec 5, 2005

Abate by

Jan 7, 2006

Penalty

Initial $375 · Current $375

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to THE HAZARD OF BEING STRUCK-BY:
a)  On or about 11/3/05 in the Receiving Area:  The overhead Load Lifter 1
1/2 ton
hoist had a damaged safety latch.
Among other methods, feasible and acceptable abatement methods to correct
to the hazard
are to:
1.  Install new safety latch on the lifting hooks in accordance with ANSI
B30.16-
1993, Section 16-1.2.9.
b)  On or about 11/3/05 in the Receiving Area:  The supporting rail for
the
overhead
Load Lifter 1 1/2 ton hoist had no load rating or capacity markings on it.
Among other methods, feasible and acceptable abatement methods to correct
to the hazard
are to:
1.  Prior to installation and use, ensure the supporting structure is
designed to
withstand the loads and forces imposed by the hoist for the rated load in
accordance
with ANSI B30.11-1980, Section 11-2.2.2.
2.  Mark the rated load on the rail in accordance with ANSI B30.11-1980,
Section
11-1.1.
Abatement documentation must be submitted for this item.

Issued

Dec 5, 2005

Abate by

Dec 13, 2005

Issued

Dec 5, 2005

Abate by

Jan 7, 2006

Issued

Dec 5, 2005

Abate by

Dec 23, 2005