SYRACUSE, NY —
OSHA Inspection: K&J ELECTRIC
Planned inspection · Health discipline
At a glance
On , OSHA opened a planned health inspection of K&J ELECTRIC in 5894 E. MOLLOY ROAD, SYRACUSE, NY 13211 (NAICS 425110). OSHA activity number 309380186.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- K&J ELECTRIC
- Site address
- 5894 E. MOLLOY ROAD
- City
- SYRACUSE
- State
- NY
- ZIP
- 13211
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Health
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 425110
- SIC code (legacy)
- 5063
- Employees
- 66
- Ownership type
- A
Citations
18 citations on file for this inspection.
5(a)(1)
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
- Penalty
- Initial $1,100 · Current $770 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to THE HAZARD OF BEING STRUCK-BY: a) On or about 3/15/06 in the Shop Storage Area: The following bridge crane/jib structures and/or supporting structures had not been rated for the capacity. 1) A crane with a 1/4 ton overhead hoist attached had no rating load markings on the crane. Among other feasible methods, feasible and acceptable abatement methods to correct this hazard is to: 1) Prior to installation and use, ensure the supporting structure is designed to withstand the loads and forces imposed by the hoist for the rated load in accordance with ANSI B30.11-1980, Section 11-2.2.2. 2) Mark the rated load markings on the crane. b) On or about 3/15/06 in the Repair Shop: The following were missing safety latches on the lifting hooks. 1) The 2 chains used to assist loads on the overhead crane had hooks that were missing their safety latches. Among other feasible methods, a feasible and acceptable abatement method to correct this hazard is to: 1. Install new safety latches on the lifting hooks in accordance with ANSI B30.16- 1993 Section 16-1.2.9.
Recent events (2)
- — I (S) $770.00
- — Z (S) $1100.00
1910.107 B05 I
- Issued
- Jul 21, 2006
- Abate by
- Jul 29, 2006
- Penalty
- Initial $1,100 · Current $770 Reduced
Recent events (2)
- — I (S) $770.00
- — Z (S) $1100.00
1910.107 E01
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (S)
- — Z (S)
1910.147 C01
- Issued
- Jul 21, 2006
- Abate by
- Jul 25, 2006
- Penalty
- Initial $1,100 · Current $770 Reduced
Recent events (2)
- — I (S) $770.00
- — Z (S) $1100.00
1910.147 C06 I
- Issued
- Jul 21, 2006
- Abate by
- Jul 25, 2006
Recent events (2)
- — I (S)
- — Z (S)
1910.147 C07 I
- Issued
- Jul 21, 2006
- Abate by
- Jul 25, 2006
Recent events (2)
- — I (S)
- — Z (S)
1910.212 A01
- Issued
- Jul 21, 2006
- Abate by
- Aug 23, 2006
- Penalty
- Initial $825 · Current $578 Reduced
Recent events (2)
- — I (S) $577.50
- — Z (S) $825.00
1910.215 B02
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (S)
- — Z (S)
1910.215 B09
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (S)
- — Z (S)
1910.252 B03 V
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
- Penalty
- Initial $1,100 · Current $770 Reduced
Recent events (2)
- — I (S) $770.00
- — Z (S) $1100.00
1910.303 B01 I
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
- Penalty
- Initial $1,100 · Current $770 Reduced
Recent events (2)
- — I (S) $770.00
- — Z (S) $1100.00
1910.303 F
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (S)
- — Z (S)
1910.303 G02 I
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (S)
- — Z (S)
1904.30 A
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (O)
- — Z (O)
1910.37 B06
- Issued
- Jul 21, 2006
- Abate by
- Jul 25, 2006
Recent events (2)
- — I (O)
- — Z (O)
1910.178 L
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (O)
- — Z (O)
1910.1200 E01
- Issued
- Jul 21, 2006
- Abate by
- Jul 26, 2006
Recent events (2)
- — I (O)
- — Z (O)
1910.1200 H01
- Issued
- Jul 21, 2006
- Abate by
- Aug 8, 2006
Recent events (2)
- — I (O)
- — Z (O)
More inspections at K&J Electric
View K&J Electric's full OSHA safety record →
More inspections in this industry (NAICS 425110)
More inspections in NY
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 309380186.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.