LONVIEW, TX —
OSHA Inspection: ECCO DRILLING CO. LTD.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ECCO DRILLING CO. LTD. in CR3600, LONVIEW, TX 75605 (NAICS 213111). OSHA activity number 309540334.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ECCO DRILLING CO. LTD.
- Site address
- CR3600
- City
- LONVIEW
- State
- TX
- ZIP
- 75605
- Mailing
- 12540 STATE HWY 155 N., TYLER, TX 75708
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 213111
- SIC code (legacy)
- 1381
- Employees
- 24
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Dec 18, 2006
- Abate by
- Dec 21, 2006
- Penalty
- Initial $875 · Current $875
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees: On or about September 19, 2006,and times prior thereto, no emergency escape descent device was installed on the derrick of Rig #6, located at a site off of CR 3600, East of Longview Tx. Employees were exposed to the hazard of fire, explosions, and no escape route from the pipe racking board. Among other methods, one feasible and acceptable abatement method to correct this hazard would be installation of a properly installed and secured emergency descent or other satisfactory auxiliary means of egress, such as specified in the American Petroleum Institute Recommended Practice for Occupational Safety for Oil and Gas Well Drilling and Servicing Operations, API Recommended Practice 54, Third Edition, August 1999, Section 6.10, Auxiliary Escape.
More inspections in this industry (NAICS 213111)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 309540334.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.