Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,198,201Inspections Most recent open 2026-08-31 Last loaded 2026-09-03

OSHA Inspection: SCHAFER DRYWALL

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of SCHAFER DRYWALL in 1684 SOUTH COLLEGE ST, AUBURN, AL 36832 (NAICS 238130). OSHA activity number 309577187.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Schafer Drywall for free Get an email when a new federal OSHA severe-injury report for Schafer Drywall is published. One employer, no account, unsubscribe in one click.
Establishment
SCHAFER DRYWALL
Site address
1684 SOUTH COLLEGE ST
City
AUBURN
State
AL
ZIP
36832
Mailing
2164 LEE RD 235, SMITHS, AL 36877
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (N)
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
SIC code (legacy)
1751
Employees
3
Ownership type
Private (A)

1 citation on file for this inspection.

5(a)(1)

Serious Gravity 03 1 instance 1 exposed
Issued
Apr 7, 2006
Abate by
Apr 13, 2006
Penalty
Initial $750 · Current $750
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to a fall hazard:
(a)Rear of building at 1684 South College St, Auburn, AL: On March 23,
2006 and
at times prior an employee  was  exposed to a fall hazard of 15 feet to
ground
from a metal prefabricated personnel platform that extended approximately
23
inches beyond the wheel base on each side of the Pettibone 636 (S/N 110683)
rough terrain forklift that supported the personnel platform.  The
employee was
installing metal studs on the outside of the building.
Among other methods one feasible and acceptable means of abatement would
be to follow the
manufactures requirements, which reference ANSI B56.6 in that the floor
dimensions of the
personnel platform shall not exceed two times the load center distance
listed on the rough terrain
forklift nameplate, measured parallel to the longitudinal center plane of
the truck, nor have a
width greater than the overall width of the truck measured across the load
bearing tires plus 10
inches on either side.r

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 309577187.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.