Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,992Inspections Most recent open 2026-07-18 Last loaded 2026-07-22

OSHA Inspection: RESINART EAST, INC.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of RESINART EAST, INC. in 201 OLD AIRPORT ROAD, FLETCHER, NC 28732 (NAICS 326199). OSHA activity number 309675825.

What this inspection record means

OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Resinart East, INC. — free Get an email when a new federal OSHA severe-injury report for Resinart East, INC. is published. One employer, no account, unsubscribe in one click.
Establishment
RESINART EAST, INC.
Site address
201 OLD AIRPORT ROAD
City
FLETCHER
State
NC
ZIP
28732
Inspection type
Planned (H)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
326199
SIC code (legacy)
3089
Employees
51
Ownership type
A
Industry flags
Manufacturing safety.

7 citations on file for this inspection.

95012901

Serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006
Penalty
Initial $125 · Current $125
North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North Carolina: The
employer did not furnish to each of his employees conditions and a place
of employment which were free from
reconized hazards that were causing or likely to cause death or serious
physical harm to employees:
a) Facility - A rated load test, with written certification, had not been
conducted on the CM 1/4 ton
hoist in the column area.
Reference:ANSI  B30.16.0 Section 16-2.2 Testing, Paragraph 16-2.2.2 Load
Tests
(b)Electric Powered or Air Powered Hoists
(1)Complete new hoists shall be dynamically load tested by the
manufacturer as specified in paragraphs 16-2.2.1(b)(1) and (2) with a
load test not less than 125of the rated load, except that if testing
cannot be performed by the manufacturer, the user shall be notified and
the load test shall be accomplished at another location or job site, by or
under the direction of a designated person prior to the hoist being placed
into service.(The user is testing the complete structure whether or not
the hoist was tested by the manufacturer.)
(c)The person conducting the load test shall prepare a written report of
the load
sustained during the test and the operations performed during the test.
Reports
must be placed on file.
Note: Among other methods, one feasible and acceptable method to correct
this hazard is to load test
the underhung hoist as required and maintain a record of the load test.

1910.179 G01 V

Serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006

95012901

Serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006
Penalty
Initial $125 · Current $125
North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North Carolina: The
employer did not furnish to each of his employees conditions and a place
of employment which were free from
reconized hazards that were causing or likely to cause death or serious
physical harm to employees:
a) Facility - The CM 1/4 ton underhung crane in the column area was not
being inspected as required.
Reference:ANSI B30.16-2003, Chapter 16-2, Section 16-2.1 Inspection,
Paragraph 126-2.1.1
Inspection Classification.
(a)Prior to initial use, all new, altered, modified hoists shall be
inspected by a
designated person to ensure compliance with this standard.
(b)Inspection Intervals. Inspection procedures for hoists in regular
service is
divided into two general classifications based upon the intervals at which
inspections should be performed:
(1) Frequent Inspections
(2)Periodic Inspections
Note:Among other methods, one feasible and acceptable method to correct
this hazard is to conduct
hoist inspections as required.

95012901

Serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006
Penalty
Initial $125 · Current $125
North Carolina General Statute 95-129(1) of the Occupational Safety and
Health Act of North Carolina: The
employer did not furnish to each of his employees conditions and a place
of employment which were free from
reconized hazards that were causing or likely to cause death or serious
physical harm to employees:
a) Facility - The under the hook lifting device, attached to the CM 1/4
ton hoist, in the column area,
had not been load tested as required.
Reference:ANSI B#).20-1985, Chapter 20-1, Section 20-1.4 Testing,
Paragraph 20-1.4.1
Operational Tests. Prior to initial use, all new, altered, modified, or
repaired lifting
devices shall be tested to ensure compliance with this standard, including
the following
functions:
(a)Moving parts. Lifters with moving parts shall be tested to determine
that the
lifter operates in accordance with the manufacturer's instructions.
NOTE:  Among other methods, one feasible and acceptable method to correct
this hazard is to properly
load test the under the hook lifting device as required.

1910.213 H01

Serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006
Penalty
Initial $100 · Current $100

1910.219 F01

Serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006
Penalty
Initial $100 · Current $100

1910.212 B

Other-than-serious 1 instance 1 exposed
Issued
Dec 29, 2005
Abate by
Jan 11, 2006

View Resinart East, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 309675825.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.