AUSTIN, TX ·
OSHA Inspection: RICHMOND AUTOMOTIVE
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of RICHMOND AUTOMOTIVE in 10800 N. LAMAR, AUSTIN, TX 78753 (NAICS 811198). OSHA activity number 309755189.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- RICHMOND AUTOMOTIVE
- Site address
- 10800 N. LAMAR
- City
- AUSTIN
- State
- TX
- ZIP
- 78753
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 811198
- SIC code (legacy)
- 7539
- Employees
- 8
- Ownership type
- A
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 28, 2007
- Abate by
- Mar 6, 2007
- Penalty
- Initial $1,500 · Current $1,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazards of being struck by rolling vehicles: a) on or about October 16, 2006, employees were exposed to the hazards of being struck by a vehicle being which rolled off the alignment machine. Among other methods, feasible and useful, to correct this hazard one method of abatement would be to provide the following: 1) a system of wheel chocks or similar restraint device outside the vehicle to prevent vehicles from inadvertently rolling off the alignment machine's inclined ramp. 2) training employees in the hazards of operating the alignment machine and the methods to control or eliminate those hazards including but not limited to following instructions in the alignment system's operator's manual. P. iii: "Read lift manufacturer's operations instructions carefully".
1904.39 A
- Issued
- Feb 28, 2007
- Abate by
- Mar 5, 2007
More inspections at Richmond Automotive
View Richmond Automotive's full OSHA safety record →
More inspections in this industry (NAICS 811198)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 309755189.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.