SCHAUMBURG, IL —
OSHA Inspection: LIBERTY SIGN COMPANY
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of LIBERTY SIGN COMPANY in 5 WOODFIELD MALL, SCHAUMBURG, IL 60173 (NAICS 238210). OSHA activity number 309958338.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LIBERTY SIGN COMPANY
- Site address
- 5 WOODFIELD MALL
- City
- SCHAUMBURG
- State
- IL
- ZIP
- 60173
- Mailing
- 507 INDUSTRIAL DR., BENSENVILLE, IL 60106
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238210
- SIC code (legacy)
- 1731
- Employees
- 1
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Aug 3, 2006
- Abate by
- Aug 8, 2006
- Penalty
- Initial $1,500 · Current $1,500
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to falls from elevations: (a) On or about April 21, 2006 an employee was using the Elliott Equipment Corporation, extensible boom vehicle mounted aerial lift, Model Number ECH-3-70-H, Serial Number LC- 1432, which tipped over onto the passenger side of the aerial basket platform. The five (5) outriggers on the vehicle were not fully extended to prevent the aerial lift from tipping over. Among other methods, one feasible and acceptable method to correct this hazard includes but not limited to the following: In accordance with American National Standard Institute (ANSI) for Safety Requirements for Vehicle-Mounted Elevating and Rotating Aerial Devices, ANSI A92.2 Section 10.8: "..Before and during each use the operator shall insure that outriggers and stabilizers are used if the manufacturer's instructions required their use and the manufacturer's operating instructions. The manufacturer's instructions (Elliot Equipment Corporation) requires the operator to always be certain all outriggers are fully spread and set firmly; and, before raising the boom, place the independently controlled outriggers on solid ground. No abatement certification or documentation is required for this item.
1910.67 C02 II
- Issued
- Aug 3, 2006
- Abate by
- Sep 20, 2006
- Penalty
- Initial $1,500 · Current $1,500
1910.67 C02 V
- Issued
- Aug 3, 2006
- Abate by
- Sep 20, 2006
- Penalty
- Initial $1,500 · Current $1,500
More inspections at Liberty Sign Company
View Liberty Sign Company's full OSHA safety record →
More inspections in this industry (NAICS 238210)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 309958338.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.